User Tag List
Thanks: 0
Likes: 0
Results 1 to 2 of 2
Thread: Laser 1 Porting Question
-
10-24-2019, 09:16 PM #1
Laser 1 Porting Question
I have an original Laser prop in 25p. I like the prop but it doesn't have any vent holes for hole shot. It has small lines just in front of the blades. Would it be ok to use a machinist type hole saw and create a larger vent hole like the mercury props? Or would this jeopardize the strength of the prop? Thanks
Respect no wake zones!!! Evinrude guys need a place to race too.
-
10-25-2019, 07:06 AM #2
Here is a pic of the venting it has. Took it at night so quality is not good.
Respect no wake zones!!! Evinrude guys need a place to race too.
Similar Threads
-
Mercury Tech: 2.4 porting question
By mt1973 in forum Technical DiscussionReplies: 12Last Post: 09-13-2010, 10:05 PM -
Porting question
By vi top shatta in forum Technical DiscussionReplies: 3Last Post: 02-03-2009, 10:24 PM -
Porting question.
By scfireman in forum Technical DiscussionReplies: 9Last Post: 11-16-2006, 09:54 PM -
porting question
By vectorizer in forum Technical DiscussionReplies: 4Last Post: 10-31-2002, 07:11 PM -
Question on Z porting VS. Bridge porting?
By Riverracer280SS in forum General Boating DiscussionReplies: 5Last Post: 09-05-2001, 08:52 AM