15" clamp

[whatsamerc??]

What all is involved in cutting a 20" clamp bracket to 15"?

[Merc 2.5]

Sending it out to Chaz Haha

[Chaz]

Thats one way ...

[JPEROG]

That would be my recommendation. I have a beat the heck out a few of them now.

There are guys starting to build billet clamp assemblies but its going to be pricey-

Joe

[whatsamerc??]

I thought it was a straight forward question. I guess not........

[Baja170]

I have two 20" single ram offshore clamps on the way to LI now. PM for details if you want one.

[Chaz]

I thought it was a straight forward question. I guess not........

"First" you need a good single ram clamp bracket. The 3 ram stuff won't go to 15"
If you don't own one , cores are available.

The swivel pin / tiller arm needs to be shortened.

The swivel bracket needs to be shortened.

The trim cylinder needs to be shortened.

Then you can install your 15" can and lower unit along with the accessories to make it shift and deliver water etc ...

There are right ways and wrong ways, short cuts , parts upgrades and everything in between ..

Reasonable enough responce ?

[Chaz]

P.S. Thank you J.P. Glad to hear they are still holdin up for ya ...

[whatsamerc??]

"First" you need a good single ram clamp bracket. The 3 ram stuff won't go to 15"
If you don't own one , cores are available.

The swivel pin / tiller arm needs to be shortened.

The swivel bracket needs to be shortened.

The trim cylinder needs to be shortened.

Then you can install your 15" can and lower unit along with the accessories to make it shift and deliver water etc ...

There are right ways and wrong ways, short cuts , parts upgrades and everything in between ..

Reasonable enough responce ?

Yes it is. Thank you