User Tag List
Thanks: 0
Results 1 to 4 of 4
Thread: Merc 2.5 Jet size?
-
10-10-2019, 05:05 PM #1Member
- Join Date
- May 2005
- Location
- Bangor, Pa
- Posts
- 66
- Thanks (Given)
- 9
- Thanks (Received)
- 0
- Likes (Given)
- 10
- Likes (Received)
- 9
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
Merc 2.5 Jet size?
I have a 96 Merc 2.5 200hp. Looking to Mill heads to 33 or 34 cc, also do Boyessen Reed's. The only add on it currently has is a Bob's lwp. My question is what size main jets should I go to once I do those two things? Not sure what size they currently have I heard .064? Any help is greatly appreciated!!
-
10-10-2019, 07:03 PM #2
Depends on what carbs you have. You most likely won’t need a jet change.
'95 STV "The Blue Goose"
-
rbeersy liked this post
-
10-11-2019, 06:59 AM #3
If ur goin to 145 -150 lbs cranking the stock jetting would b to lean for my liking , then it sure wont b on the safe side , it would b on the edge of lean is what i would think , i run wh carbs on 2.5 with 86s with 145 150 lbs and little port work
-
rbeersy liked this post
-
10-12-2019, 11:15 AM #4
Mercury jetted stock motors very safe from factory, highly doubt that with just those mods any jet changes will be needed. If your worried do a cut at max rpm then check plugs and piston wash to see if you lean.
Dave1980 Cougar 19 tunnel,90 2.4L Bridgeport EFI in middle of restoration.
1988 BAJA Sunsport 186, 96 225 Pro Max
79 12' Auminum, 95 Merc 9.9
RIP Stu
"So many idiots, so few bullets"
-
rbeersy liked this post
Similar Threads
-
Mercury Tech: Tilt tube Zerk fitting size and thread size??
By Sheer Insanity in forum Technical DiscussionReplies: 1Last Post: 07-25-2012, 09:12 AM -
89 135 hp Merc What liter size? 2.0 or 2.4
By tdogcarter in forum Technical DiscussionReplies: 2Last Post: 03-30-2006, 10:45 PM -
What size fuse (MERC 200)
By vols1963 in forum Technical DiscussionReplies: 1Last Post: 06-24-2003, 04:00 PM -
Merc V-6 Model/size I.D.???
By B.Mac in forum Technical DiscussionReplies: 2Last Post: 07-06-2001, 10:23 AM