STV 4yr LOL..referb almost done...

[Tom Foley]

Thanks I hope.. I need Dave to come to fl on vacation about now LOL..

Will you be ready for the Suwannee in November (14th) .

[H2OPERF]

Man i sure hope so, i looked last week and i work that weekend trying to get if off..

[jmatak9]

I hope your there, I would love to see this boat in person! Can I get the info on the windshield? I'm in need of one like that.

[JPEROG]

What a beautiful weapon you have built--Love it, nice job and can't wait to (see, hear, and smell) it in person. That flywheel looks a little heavy LOL... You definitely went the full run on this thing and there won't soon be another like it.

Joe

[H2OPERF]

Thanks for all the compliments guys, but it is a painted up 1991 so shes not like a new one inside and out. I have some buffing to do on the bottom half and some day would like to put a nice aluminum trailer under it.. Any one on here making carbon seat shells? i'm putting in the old back seat but its a bit ratty and might be easier to buy than fix this one up.. Thanks , Dave

[Hot Shot Merc]

That's beautiful right there! That engine looks bad azzzz too! Congrats on your new toy

[AZMIDLYF]

Thanks for all the compliments guys, but it is a painted up 1991 so shes not like a new one inside and out. I have some buffing to do on the bottom half and some day would like to put a nice aluminum trailer under it.. Any one on here making carbon seat shells? i'm putting in the old back seat but its a bit ratty and might be easier to buy than fix this one up.. Thanks , Dave

CDR has some..https://www.facebook.com/performancecowls/

[AZMIDLYF]

Is that a carbon slide on that motor?

[patchesII]

Thanks I hope.. I need Dave to come to fl on vacation about now LOL..

I think you’ll pick up Emtune pretty quick. I found it very intuitive. The 3D modeling of the fuel map is killer and really makes it easy to wrap your head around what is going on

[H2OPERF]

Is that a carbon slide on that motor?

The velocity stacks are the rest is aluminum...

[H2OPERF]

No nothing hits, the pulleys clear the boat in a full turn too, there are nylon plastic stops at the bottom of the bracket/plate that double as the side thrust sliders that hit the notches in the mid .. when the motors trimmed all the away up the plate will hit because the stops are way too far away and with string/cable steering there's no cylinder or teleflex cable to bottom out and limit the motor travel somethings gotta interfere. The original f1 had way more down trim i wanted more up for sand bar beaching ect . The cables don't slack at all on neutral to full down and full running up trim and only slightly when way above what you would run,i think really good as those systems go. Everything has cable guards too so nothing can come off a pulley.

[H2OPERF]

well i was answering question but post is gone...

[oldschoolltv]

Love the shift cable, nice and simple way to adapt the sporty.

[H2OPERF]

Thanks, didn't want to mess with drilling the swivel pin and possibly messing it up especially with it being such a rare part..

[pearlriverrat]

well i was answering question but post is gone...

I thought more about it after I posted and realized it pivoted further back than I first envisioned. The picture didn't attach to the reply, but in that particular picture, it looked really tight.
Very nice work, on all of it.