2001 STV Procomp Ski bottom

[Hungry]

1991 STV Procomp with the ski bottom. Complete with a newlyrebuilt powerhead on a 2005 3.3 250 hp Yamaha which now has 5 1/2 hours on thebreak in. Built by JTM motors Who builds mostly big block Yamaha motors and anoccasional Mercury. This build includes Wisco pistons performance heads, bigbore throttle body, solid engine mounts, fuel enrichment rheostat, flashedcomputer by Simon and a lightened flywheel. The lower unit went out to HydroTec who coned elongated and shaped the lower unit for high-speed. Also rebuiltwith the new bearing carrier and heavy duty prop shaft, (fat shaft) and low-water pick up. Aluminum trailer withtorsion bar suspension hydraulic steering, Optima battery, three bilge pump‘s, blinkertrim, two different props etc. Turn Key Ready $25000 cautela59@yahoo.com

[Ripnfool]

Would u separate ???

[BRB]

Stv didn't build a procomp or a ski bottom in 2001...1994 was the last year...sorry

[aggiestckl]

Must be a $19,000 Yamaha

[Hungry]

Just going by what the title says. Not sure what you are saying. I'm not an expert on STV's but you say that 1994 was the last year made then when did they start?

[Hungry]

Possibly, what are you interested in?

[BRB]

They built the procomp with the ski bottom from late 1989 to 1994...something isn't right with the title...Js

[H. Hogan]

The hin# should be engraved on the starboard side of the transom close to the rub rail. Hope it helps.

[Hungry]

Well sir I apparently do not know how to proofread my ownposting. My mistake the title is correct at 1991 not 2001, it’s been a longweek. Thank you for catching my mistake I have corrected it.