User Tag List
Thanks: 0
Likes: 0
Results 1 to 3 of 3
-
08-25-2019, 07:14 PM #15000 RPM
- Join Date
- Aug 2019
- Location
- Palmharbor
- Posts
- 558
- Thanks (Given)
- 20
- Thanks (Received)
- 23
- Likes (Given)
- 58
- Likes (Received)
- 150
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
Best way to turn up a 3.3 ltr Evinrude
Can do the DBR pistons V8 rods sleeves block work questions
longivity #1 usable power 3500 cruse, do I ditch the stock Ecu and use doner ocean pro carbs an electronics with a 8500 rpm cdi or go with a motec ecu a have it programmed as a do or as one of my old school wrencher said to use a yami comp an modify the front half for injectors ad a oxygen sensor in exhaust adaptor an let it rip it will self learn any reasonable alternative besides a low torque air injected high rever no pun intended the engine dosent have a header so it dosent have lowen torque unless it’s on a potato chip hull I have seen many under prop just to get on top nice part about being a long time mech got to do at least 1k + sea trials on many different boats powered by the major merc johnrude yami suzukiLast edited by MrG; 08-25-2019 at 07:17 PM.
-
08-26-2019, 09:44 AM #25000 RPM
- Join Date
- Nov 2009
- Location
- hardyville va
- Posts
- 367
- Thanks (Given)
- 7
- Thanks (Received)
- 38
- Likes (Given)
- 1
- Likes (Received)
- 43
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
What is the donor motor and the application? Too many questions, not enough info.
-
08-26-2019, 12:28 PM #35000 RPM
- Join Date
- Aug 2019
- Location
- Palmharbor
- Posts
- 558
- Thanks (Given)
- 20
- Thanks (Received)
- 23
- Likes (Given)
- 58
- Likes (Received)
- 150
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
Center counsel 21 ft offshorehttps://youtu.be/Hlyxok6634k
Donor is a 2008 225 Etec one bad piston over heat scuffed plastic bag syndrome ,water pomp was fine but showing a rubber transfer in center of impeller this run in the vid was before the jack plate was doing 68 mph you can see the tac holding redline 6700
Similar Threads
-
Twin Outboards, Turn In or Turn Out ?
By Tightrig 12 in forum Technical DiscussionReplies: 13Last Post: 08-18-2018, 08:25 AM -
Mercury Tech: How can I tell what gear ratio I have? Prop turns 1/2 turn per full turn of flywheel
By phaster in forum Technical DiscussionReplies: 3Last Post: 07-20-2010, 06:36 PM -
Turn,Turn Turn Lady Hustler Ejected By www.freezeframevideo.net
By Freeze Frame Video in forum General Boating DiscussionReplies: 1Last Post: 03-26-2010, 07:32 PM -
Turn,Turn,Turn Lady Hustler Ejected video by Freeze Frame
By Freeze Frame Video in forum General Boating DiscussionReplies: 0Last Post: 03-24-2010, 05:04 AM -
a15 analog box turn clockwise or counter clockwise too turn richer
By MENNO in forum Technical DiscussionReplies: 9Last Post: 03-30-2004, 02:52 PM