User Tag List

Thanks Thanks:  0
Likes Likes:  0
Results 1 to 3 of 3
  1. #1
    Join Date
    Aug 2019
    Location
    Palmharbor
    Posts
    557
    Thanks (Given)
    20
    Thanks (Received)
    23
    Likes (Given)
    58
    Likes (Received)
    150
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)

    Lightbulb Best way to turn up a 3.3 ltr Evinrude

    Can do the DBR pistons V8 rods sleeves block work questions

    longivity #1 usable power 3500 cruse, do I ditch the stock Ecu and use doner ocean pro carbs an electronics with a 8500 rpm cdi or go with a motec ecu a have it programmed as a do or as one of my old school wrencher said to use a yami comp an modify the front half for injectors ad a oxygen sensor in exhaust adaptor an let it rip it will self learn any reasonable alternative besides a low torque air injected high rever no pun intended the engine dosent have a header so it dosent have lowen torque unless it’s on a potato chip hull I have seen many under prop just to get on top nice part about being a long time mech got to do at least 1k + sea trials on many different boats powered by the major merc johnrude yami suzuki
    Last edited by MrG; 08-25-2019 at 07:17 PM.

  2. #2
    Join Date
    Nov 2009
    Location
    hardyville va
    Posts
    367
    Thanks (Given)
    7
    Thanks (Received)
    38
    Likes (Given)
    1
    Likes (Received)
    43
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    What is the donor motor and the application? Too many questions, not enough info.

  3. #3
    Join Date
    Aug 2019
    Location
    Palmharbor
    Posts
    557
    Thanks (Given)
    20
    Thanks (Received)
    23
    Likes (Given)
    58
    Likes (Received)
    150
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Center counsel 21 ft offshorehttps://youtu.be/Hlyxok6634k
    Donor is a 2008 225 Etec one bad piston over heat scuffed plastic bag syndrome ,water pomp was fine but showing a rubber transfer in center of impeller this run in the vid was before the jack plate was doing 68 mph you can see the tac holding redline 6700

Similar Threads

  1. Twin Outboards, Turn In or Turn Out ?
    By Tightrig 12 in forum Technical Discussion
    Replies: 13
    Last Post: 08-18-2018, 08:25 AM
  2. Mercury Tech: How can I tell what gear ratio I have? Prop turns 1/2 turn per full turn of flywheel
    By phaster in forum Technical Discussion
    Replies: 3
    Last Post: 07-20-2010, 06:36 PM
  3. Turn,Turn Turn Lady Hustler Ejected By www.freezeframevideo.net
    By Freeze Frame Video in forum General Boating Discussion
    Replies: 1
    Last Post: 03-26-2010, 07:32 PM
  4. Turn,Turn,Turn Lady Hustler Ejected video by Freeze Frame
    By Freeze Frame Video in forum General Boating Discussion
    Replies: 0
    Last Post: 03-24-2010, 05:04 AM
  5. Replies: 9
    Last Post: 03-30-2004, 02:52 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Aeromarine Research