User Tag List
Thanks: 0
Likes: 0
Results 1 to 5 of 5
Thread: 2.4 200 EFI Wiring
-
06-09-2019, 08:17 PM #1
2.4 200 EFI Wiring
Re-wiring my engine after being disassembled for 5 years. My harness from 8 pin connector has 3 black/yellow wires coming out of it, my wiring diagram shows 1 wire going to each switch box. Not sure where the extra black/yellow wire goes? Also, there's a capacitor (at least it looks like one) just above and to the left of the switch boxes, directly to the left of the starter solenoid, don't see it in the manual I have. Any help would be appreciated!
Last edited by idvette; 06-09-2019 at 08:53 PM.
-
06-10-2019, 01:03 AM #2
that's a "mercury" switch that will kill tha ign. circuit when trimmed up to high
-
06-10-2019, 06:06 AM #3
Aaahhh.... So the black/yellow likely goes to that switch then?
-
06-10-2019, 06:50 AM #4
yes sir..
-
06-10-2019, 06:55 AM #5
Thanks!
Similar Threads
-
Mercury Tech: 2.5 wiring help
By jmadisonbiii in forum Technical DiscussionReplies: 2Last Post: 06-07-2015, 06:06 PM -
wiring diagram for 7 pin cannon connector at motor//wiring to start on engine stand
By seabold in forum Technical DiscussionReplies: 9Last Post: 10-24-2013, 08:50 PM -
DSC wiring into VHF....
By Trippin in forum Electronics, Audio Systems, and WiringReplies: 1Last Post: 05-04-2005, 09:49 PM -
Need Help W/ecu Wiring!!
By JASON ALLEN in forum Technical DiscussionReplies: 5Last Post: 04-19-2005, 11:15 PM -
Wiring
By Richard in forum Technical DiscussionReplies: 2Last Post: 02-19-2002, 06:26 PM