User Tag List
Thanks: 0
Likes: 0
Results 1 to 3 of 3
-
05-24-2019, 07:55 AM #1Member
- Join Date
- Oct 2009
- Location
- Lake Conroe, Tx
- Posts
- 63
- Thanks (Given)
- 4
- Thanks (Received)
- 2
- Likes (Given)
- 6
- Likes (Received)
- 30
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
2.4 fishing motor on a 1 pce exhaust plate
Putttin a 2.4 on a one pce Bridgeport exhaust plate. Have done it in the past, but wondering how everyone routes the water dumps. I dump off the head, remove the poppet and dump off it, and dump off one side of the exhaust plate. I have seen people dump off both heads, no heads and no exhaust plate dump. Merc hi po is normally head and poppet i think, Whats the best way?
-
05-24-2019, 10:41 AM #2
1/8 inch fender washers in place of the thermostats dump off one head..remove the poppet entirely and dump off of that with a restrictor to get to your water pressure/temp delta. You may end up with the poppet dump plugged off.
-
05-24-2019, 11:52 AM #3Member
- Join Date
- Oct 2009
- Location
- Lake Conroe, Tx
- Posts
- 63
- Thanks (Given)
- 4
- Thanks (Received)
- 2
- Likes (Given)
- 6
- Likes (Received)
- 30
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
Yea, that what i planned on doing. In the past i have dumped off the exhaust plate, but am not going to this time. I already have the 1/8 in washers in place of the thermostats, and the poppet is pulled with a 3/8 hose coming off of it. With the one piece plate that seems to be right. Thanks
Similar Threads
-
2.5L Mercury Reed Plate (Fishing motor 5/4 peddle)
By StratosVT in forum Misc. Parts and AccessoriesReplies: 0Last Post: 08-08-2016, 01:44 PM -
drilling exhaust holes.. 2.4 fishing motor
By 2springers26 in forum Technical DiscussionReplies: 8Last Post: 07-27-2003, 04:21 PM