User Tag List
Results 16 to 20 of 20
Thread: Hydroplane Engine Help
-
05-03-2019, 09:00 PM #165000 RPM
- Join Date
- Apr 2015
- Location
- Oceanside, NY
- Posts
- 155
- Thanks (Given)
- 20
- Thanks (Received)
- 10
- Likes (Given)
- 51
- Likes (Received)
- 119
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
[QUOTE=rock;3130728]You are very welcome Sean. As a retired cabinet maker Rock[/QUOTE
I started out as a cabinet maker before teaching.
I used to wish I stuck with the cabinet making until i switched to high school.
-
05-04-2019, 06:25 PM #175000 RPM
- Join Date
- Apr 2015
- Location
- Oceanside, NY
- Posts
- 155
- Thanks (Given)
- 20
- Thanks (Received)
- 10
- Likes (Given)
- 51
- Likes (Received)
- 119
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
-
05-05-2019, 10:33 AM #18
Looks like it will fit just fine. I have a 20" mid with a bad lower on it, a 15" mid with lower, a powerhead, a prop, and an unattractive cowling. Looks to be enough there to get you going. PM an address and I will get this mess boxed up and off to Fastenal. You are welcome to both mids and I would suggest taking both of them till you know for sure which way you need to go. It's going to cost a bit more to box and ship but in my opinion would be well worth the few bucks extra the shipping may cost. Beside the cost of shipping you will be responsible for sending me a pic of finished project surrounded by the kids that built it. Even better than that would be a picture of the grin on the face of the first kid to drive it.
RockTeam Junk
No sparkling wiggles in here, only dump truck grinches.
"Screamin Heathen"
-
outboards4life liked this post
-
05-05-2019, 10:48 AM #19Screaming And Flying!
- Join Date
- Dec 2001
- Posts
- 9,502
- Thanks (Given)
- 23
- Thanks (Received)
- 271
- Likes (Given)
- 191
- Likes (Received)
- 1976
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
Back in 1969 My shop teacher helped me sand cast port stuffers ........JHigh school.......bet they don't have shops like that anymore........Merrick LI......Brookside High......I stayed away from wood shop......was scared of saws.......Failed English.....any one here notice ?
-
rock liked this post
-
05-05-2019, 02:47 PM #20
I think you are getting a very good motor for this project
Similar Threads
-
Looking for a d hydroplane
By yellowfever in forum Hulls WantedReplies: 8Last Post: 06-17-2015, 07:40 AM -
The old hydroplane
By afr in forum Racer's HangoutReplies: 0Last Post: 12-05-2012, 01:00 PM -
jet hydroplane?
By KEVIN NICHOLS in forum Technical DiscussionReplies: 11Last Post: 04-01-2003, 06:57 PM