User Tag List
Results 1 to 15 of 18
-
04-19-2019, 07:48 PM #1Member
- Join Date
- May 2016
- Location
- Long Beach, CA
- Posts
- 55
- Thanks (Given)
- 12
- Thanks (Received)
- 0
- Likes (Given)
- 1
- Likes (Received)
- 0
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
1985 merc 200 - just rebuilt carbs.. no start
Hi all - it puffs and runs a tiny bit when i try starter fluid. Carbs squeaky clean- also i cant exactly recall but 99% sure, the upper carb jets that sit up top and face wd - I have it like so:
Blank - Jet (top carb)
Jet - Jet (middle)
Jet - Blank) (Lower carb) -
Also think i "might" have forgotten about the enricher tube - its all plugged but I have the front baffle/box removed so I can see into carbs and look for any leaks.
I set the floats parallel to the body inverted (they hang out about 1-2mm -
is this correct? carbs are stamped 1374-7561 -
Sorry forgot to grab the s/n!
I pulled plugs and cleaned the round center electrode things - they were a little fouled.. Gonna try new gas next time im there - I felt a little buzz/shock on my hand when I was hot wiring the starter from the side of the motor.. i might crank it at night to see if there are any sparks.. Seems like there might be a leak somewhere in the wires or something - it shouldnt do that right??
Last edited by Fstarockr; 04-19-2019 at 07:51 PM.
-
04-19-2019, 10:37 PM #26000 RPM
- Join Date
- Feb 2014
- Location
- Missouri
- Posts
- 1,212
- Thanks (Given)
- 2
- Thanks (Received)
- 66
- Likes (Given)
- 12
- Likes (Received)
- 83
- Mentioned
- 1 Post(s)
- Tagged
- 0 Thread(s)
Can you smell gas after a cupple cranks.
I guess we we can start with last repair. Are all the parts in nothing left out and adjustment screws set correctly or in last operating condition.
-
04-19-2019, 10:50 PM #3Member
- Join Date
- May 2016
- Location
- Long Beach, CA
- Posts
- 55
- Thanks (Given)
- 12
- Thanks (Received)
- 0
- Likes (Given)
- 1
- Likes (Received)
- 0
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
yes the same.. wd the enricher make that much of a difference?
-
04-20-2019, 03:49 AM #4
did it run "before" ya did carbs?
-
rgsauger liked this post
-
04-20-2019, 10:00 AM #5Member
- Join Date
- May 2016
- Location
- Long Beach, CA
- Posts
- 55
- Thanks (Given)
- 12
- Thanks (Received)
- 0
- Likes (Given)
- 1
- Likes (Received)
- 0
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
yeah guy said it wouldnt idle for a ehile, carbs were gunked up. I found the jetting chart and confirmed these are WH22 carbs so will follow that thanks. I think he mucked with idle screw cos it was REALLY jammed against the cables but 1/8 of an inch!
-
03-12-2020, 09:15 PM #6
you do know that 1/4 screw has "0" ta do with idle rpm/speed right?
Last edited by tlwjkw; 03-12-2020 at 09:17 PM.
-
03-13-2020, 06:25 AM #7
Sounds like more problems than just carbs if you really never herd it run and have to hot wire the SIDEof the motor and getting shocked and tubes are gunked up and screws are cranked on.
-
03-13-2020, 06:51 AM #8
I think ur describing the bowl vent jets , wont cause ur issue ,,
Have u checked spark? , did u forget a float haha, gonna need to know what kind of test u have done so far , pump bulb real hard and hold pressure on it and c if carbs puke out the front, then pull plug and do spark and gap test to start with
-
03-13-2020, 11:49 AM #9
Does the enrichment solenoid click? are the hoses hooked up the right way?
Dave1980 Cougar 19 tunnel,90 2.4L Bridgeport EFI in middle of restoration.
1988 BAJA Sunsport 186, 96 225 Pro Max
79 12' Auminum, 95 Merc 9.9
RIP Stu
"So many idiots, so few bullets"
-
03-13-2020, 05:27 PM #10
Put your hand over one carb and crank to choke it. I you don't get gas on your hand the bowls are dry. If you do get gas and it doesn't fire you don't have spark.
96 Cougar 23 MTR twin 300XS's. 100 something
98 Laveycraft Sebring 20.2 Tunnel 280 90 something SOLD
85 Baker RST 220 Laser SOLD
-
03-13-2020, 06:40 PM #11
I'm sure a year later he is appreciating the advice
-
luv2gofast thanked for this postluv2gofast, mrichartz liked this post
-
03-13-2020, 06:56 PM #12
-
03-13-2020, 07:27 PM #13
-
Dave Strong liked this post
-
03-13-2020, 07:36 PM #14
-
03-13-2020, 07:48 PM #15
really, really good drugs...................................................
-
Dave Strong liked this post
Similar Threads
-
rebuilt 125 carbs on 100 merc 97'
By luckybuff in forum Technical DiscussionReplies: 0Last Post: 06-28-2008, 08:32 PM -
Rebuilt a Mercury 115 HP and is now hard to start.
By ronnyd8719 in forum Technical DiscussionReplies: 12Last Post: 01-09-2007, 06:53 AM