How To ?! Splitting a foam-filled or foam core boat?

[Chaz]

I think he's dunn a great job ...

# 1 .. Look at all that foam on the ground, trailer's axle deep in the stuff ..

# 2 .. He's kept FuMP glued to his seat for three pages with a $ 2 dollar boat .

# 3 .. Where's power with an epa report on styrene ..

C 6 H 5 CH=CH 2

[home made tunnel]

Haha - I'm a glutton for punishment.

AND it's easy to pick up free boats in new England... or you could call them Land Lakes. Parked Ponds. Vessel Dumpsters.
But hey, cheap is cheap!

I may take the chainsaw too it yet... I went on vacation to Orlando, and apparently leaving it propped up on edge with 2x4's and a tire on snow was a bad idea... Yea, it melted and fell over hahaha.

[FMP]

If you do decide to scrap it maybe all that jet drive could be worked into the wife's sister's husband's uncle's project boat. That would be a cool retro if the height permits.
Best wishes for #2!

[home made tunnel]

If you do decide to scrap it maybe all that jet drive could be worked into the wife's sister's husband's uncle's project boat. That would be a cool retro if the height permits.
Best wishes for #2!

Worst case is I chain-saw the jetboat, and put the jet drive in a mini-most XL. OR an aluminum hull jetboat that I could weld together.

[RSWORDS]

Worst case is I chain-saw the jetboat, and put the jet drive in a mini-most XL. OR an aluminum hull jetboat that I could weld together.

https://www.pirate4x4.com/forum/gene...ld-thread.html

Start reading.

It gets REALLY awesome near the end when he starts casting his own parts.