User Tag List
Thanks: 0
Results 1 to 6 of 6
Thread: Vst pump
-
02-11-2019, 05:45 AM #15000 RPM
- Join Date
- Mar 2002
- Location
- SW FLA
- Posts
- 162
- Thanks (Given)
- 3
- Thanks (Received)
- 0
- Likes (Given)
- 0
- Likes (Received)
- 0
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
Vst pump
My pumps bad what's best way to replace pump
-
02-11-2019, 07:12 AM #2Supporting Vendor
- Join Date
- Apr 2001
- Location
- Brookeland , Texas 75931 North of Jasper
- Posts
- 11,838
- Thanks (Given)
- 4
- Thanks (Received)
- 163
- Likes (Given)
- 11
- Likes (Received)
- 795
- Mentioned
- 1 Post(s)
- Tagged
- 0 Thread(s)
Remove VST tank top , then remove and replace pump , pretty straight forward .
Are you sure your circuits to start your pump in your ECU hasn’t failed ? I sometime have to use a relay on some that has failed , I use a relay attached to pump to get power to the pump and I use the keyed switch hot purple wire to excite the relay , when key is turned on relay closes then pump starts .. Just a thought !
JayLast edited by Jay Smith; 02-11-2019 at 07:17 AM.
Jay @ JSRE
-
02-11-2019, 07:48 AM #3Screaming And Flying!
- Join Date
- Mar 2008
- Location
- Tourist Trap, Florida
- Posts
- 14,753
- Thanks (Given)
- 381
- Thanks (Received)
- 1305
- Likes (Given)
- 5602
- Likes (Received)
- 11033
- Mentioned
- 2 Post(s)
- Tagged
- 1 Thread(s)
Jay are there any other good options for an elec pump replacement part on the stock 2.5's (other than merc ) worth messing with?
Have seen some on e- bay and was dubious about quality.
83 V-King, 96 Mariner, 200 hp ff block 2.5 w/a 28p choppa
We gotta clean this liberal mess up, VOTE TRUMP TO MAGA!
Rebuild thread:
http://www.screamandfly.com/showthre...-it&highlight=
http://www.screamandfly.com/showthre...cs.&highlight=
Videos
-
02-11-2019, 09:21 AM #45000 RPM
- Join Date
- Mar 2002
- Location
- SW FLA
- Posts
- 162
- Thanks (Given)
- 3
- Thanks (Received)
- 0
- Likes (Given)
- 0
- Likes (Received)
- 0
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
Thanks for the reply pump has 12 volts I added 12volt battery power still nothing reversed leads to maybe spin backwards still nothing is there a part # for replacement internal vst pump.Thanks Jay
-
02-11-2019, 09:40 AM #5Supporting Vendor
- Join Date
- Apr 2001
- Location
- Brookeland , Texas 75931 North of Jasper
- Posts
- 11,838
- Thanks (Given)
- 4
- Thanks (Received)
- 163
- Likes (Given)
- 11
- Likes (Received)
- 795
- Mentioned
- 1 Post(s)
- Tagged
- 0 Thread(s)
I have folks ace the VST and go with a 260 style pump and return system , cleans that side up but pricey , Dunno pump part number sorry , and dunno if there is a generic pump that’s a direct bolt on ???
JayJay @ JSRE
-
02-11-2019, 11:50 AM #6Member
- Join Date
- Jul 2018
- Location
- Bonneau beach SC
- Posts
- 52
- Thanks (Given)
- 0
- Thanks (Received)
- 6
- Likes (Given)
- 3
- Likes (Received)
- 15
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
12v is always on the positive lead to pump, ecm provides the ground
to complete the circuit.
Similar Threads
-
Trim Pump or Jack Plate Pump Mounting Plates, Solenoids and Harness
By Onetime in forum Misc. Parts and AccessoriesReplies: 8Last Post: 09-10-2021, 08:35 PM -
Rigging Accessories and Parts (Mercury Race Trim Pump, Fuel Pump, Steering, ETC)
By kcoleman10 in forum Misc. Parts and AccessoriesReplies: 7Last Post: 11-26-2013, 08:58 PM -
mallery fuel pump, why does it have a small fitting on bottom of pump?????
By camaro7081 in forum Technical DiscussionReplies: 9Last Post: 05-25-2007, 09:16 PM