2000 JSRE ProMax For Sale

[Bulletman20]

New Pro XS going on this week so my JSRE built Promax is now For Sale. Est. 100/110 hours since rebuild. Local Shop just did complete check of motor with clean bill of health (Checklist Available). Compression was nearly the same as it was when it left Jay's Shop (All 140+-5). I fish, I don't run up and down the lake trying to see how fast I can go. Most of the time on the motor is at or below 4500 RPMs and most of it idling.The motor has NOT been run hard. I can only remember 1-2 times it was run close to the limiter. Motor is very strong!




All Merc HP parts (except reeds) used in the rebuild:

New Top Pinned Pistons

New Crankshaft

Pistons & Rods Balanced

34CC Radial Cut Heads

Front and Rear halves Polished

Front Shaved .050

Reed Cage Lapped .050

TDR Reeds

Intake ports opened up some

All voids filled with epoxy

Injectors flowed and cleaned by Brucato

ECU checked by Brucato (Stock Rev Limiter)

Rebuilt fuel pump and tank

Fuel pressure increased to 40 PSI

All new oil tubes/hoses

New voltage regulators

New Power Packs (recent)

Exhaust Can removed but will go with motor w/new gaskets

Custom built Bob's coned 200 LU with heavy Duty TM 1.87 gears and bearing carrier (Hidden Water Hose)

2- Trophy Plus Props w/Hub Kits (26/27P)

Custom Decals on Cowling




$6500 Firm

If interested or questions Text or Call me @ 210-983-9830

[Bulletman20]

As it says at the top of the thread to motor is SOLD SOLD SOLD