300 promax/X Flush valve port

[2.5-21]

Is there any out there or do I need to order a new one?


https://www.boats.net/product/mercury/840251A1

[kct11]

Do you know how to change it? Looks like it's glued into the pan. Mine got cracked from probably over tightening. Just holding off because it looks like a pain.

[2.5-21]

Do you know how to change it? Looks like it's glued into the pan. Mine got cracked from probably over tightening. Just holding off because it looks like a pain.

It is Glued into pan, The one I have I bought used and was unglued and appears to have been epoxied previously. I would assume only going to be available new?

[kct11]

How did the old one come out for you? That's if you done it yet. Just wondering if it cracks or chips the pan taking it out.

[2.5-21]

How did the old one come out for you? That's if you done it yet. Just wondering if it cracks or chips the pan taking it out.

I bought a used pan and it wasnt in it when I got it. Probably just chip it out with a pair of pliers and rough up surface with an angle grinder it is only glued in from inside

[2.5-21]

I would like to adapt this with a plug in it to avoid having a cheap piece of plastic that cost 75 bucks break