1988 Eliminator Stoker Sport Tunnel 20’ w/ Mercury 200

**breezly** · 09-05-2018, 07:04 PM

1988 Eliminator Stoker Sport Tunnel 20' For Sale. I got the boat off of a trade. Previous owner was a Mercury Tech in training who purchased the motor as his project and rebuilt it. I've had this boat a little less than a year and have used it about 3-4 weekends.

Boat has its original gel coat and does show obvious signs of wear. Motor is a Mercury 200 Black Max with 2.5 Lower Unit and 22P Chopper that has been completely gone through from top to bottom with new

-Spark Plug Wires
-Spark Plugs
-Power Packs
-Rectifier Regulators
-Fuel Pump Rebuild
-Trim Motor
-Impeller

Interior bucket seats came with boat but a new carpet has been installed. Boat has also been completely gutted and replaced with new
-Mercury Rigging & Harness
-Interstate Battery
-Gaffrig Gauges
-Fusion Bluetooth MS-RA70 & 2- 6" Fusion Speaker
-Fuel Senders
-Bilge Pumps
-Fuel Filter & Housing

Trailer was recently redone with new wiring , lights , hubs, tires , & wheels.

Title in hand

Asking $7500 OBO- Shipping must be arranged by buyer

**silverfox** · 09-06-2018, 12:26 PM

Is the ding on the port bow deep or a surface thing? How is the transom and bottom?
Bill Hoch
Stuart, Fl

**breezly** · 09-06-2018, 01:01 PM

That is not a ding of any sort , it is the gel coat that’s faded in that area. The transom and floor are in good condition to my knowledge. I will put up a picture up in a bit of that port bow fading up close.

**breezly** · 09-06-2018, 01:02 PM

Bottom *

**silverfox** · 09-06-2018, 01:28 PM

I saw the cavitation plate are missing from the transom. Do you have them yet? The plates were bolted thru the bottom of the tunnels. Did the holes get filled in?
Bill

**breezly** · 09-06-2018, 01:37 PM

I have the plates , as well as the turnbuckles and hardware. The holes were filled by previous owner. A replacement turnbuckle does need to be purchased,, the old one broke off and that’s why previous owner removed the cavitation plates and filled holes.