User Tag List
Results 1 to 12 of 12
-
04-18-2018, 10:09 PM #1
mercury 260 under a mod vp cowl???
anyone running that setup?
or any horn under the mod vp cowl?
especially with 1" spacer?
looking for measurements and clearance confirmation
thanks81' HYDROSTREAM VECTOR / slightly Modified 200
before and after:http://www.screamandfly.com/showthre...inished!/page3
-
04-19-2018, 07:27 AM #2
Yep.
-
texasvector, Michael J Giesler liked this post
-
04-19-2018, 02:15 PM #381' HYDROSTREAM VECTOR / slightly Modified 200
before and after:http://www.screamandfly.com/showthre...inished!/page3
-
mach351, WillySteve liked this post
-
04-19-2018, 03:29 PM #4
I run an old vp cowl on my champ boat with a horn/spacer.
-
texasvector liked this post
-
04-19-2018, 04:56 PM #5
any mods to get the air in the horn?... molded front plate and all
81' HYDROSTREAM VECTOR / slightly Modified 200
before and after:http://www.screamandfly.com/showthre...inished!/page3
-
04-19-2018, 04:57 PM #6
not sure how nass cowl measures up to factory. .... but my measurements current block and cowl it's gonna be tight!
81' HYDROSTREAM VECTOR / slightly Modified 200
before and after:http://www.screamandfly.com/showthre...inished!/page3
-
04-19-2018, 06:29 PM #7
I don't have a front plate there is a piece of flexible hose connected to the cowl. My cowl is the newer version with the naca ducts on the side
-
texasvector, wickedwitthestix thanked for this posttexasvector liked this post
-
04-23-2018, 09:02 PM #8
-
texasvector thanked for this post
-
04-22-2019, 01:56 PM #9Junior Member
- Join Date
- Apr 2019
- Location
- Azle , Texas
- Posts
- 26
- Thanks (Given)
- 3
- Thanks (Received)
- 0
- Likes (Given)
- 0
- Likes (Received)
- 2
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
Don’t know if this helps . Just know the unit i have , has a horn . Just have no knowledge of mine till next week .
-
04-23-2019, 08:12 AM #1081' HYDROSTREAM VECTOR / slightly Modified 200
before and after:http://www.screamandfly.com/showthre...inished!/page3
-
04-23-2019, 04:56 PM #11
That plate doesnt look like its 1", more like 1.5-2! I know with a 1" spacer plate the tip of the horn is close on a 260 cowl not sure about a mod vp.
-
texasvector liked this post
-
04-23-2019, 07:50 PM #12
lil less than 2" ...worst case scenario ill have to put a slide on the front
81' HYDROSTREAM VECTOR / slightly Modified 200
before and after:http://www.screamandfly.com/showthre...inished!/page3