User Tag List
Thanks: 0
Likes: 0
Results 1 to 4 of 4
Thread: Oil Injection Wiring
-
03-18-2018, 06:32 PM #15000 RPM
- Join Date
- Jul 2008
- Location
- Portland Oregon
- Posts
- 100
- Thanks (Given)
- 0
- Thanks (Received)
- 0
- Likes (Given)
- 0
- Likes (Received)
- 2
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
Oil Injection Wiring
I'm putting a 2002 200 block back together. I installed the merc plug in the injection and plan to run premix, but do I need to do anything with the three wires going to the sensor above the plug? Am i going to get an alarm?
-
03-18-2018, 06:39 PM #2
Not sure if your oil injection is the same as my older Merc V6 stuff, but on all mine I put the plug in the block, pulled the sensor and module off and tossed them, along with all the tanks and hoses...good riddance ! No alarm problems.
James H. W2F a V-King... Want 2 Fly a V-King
Dedicated Site for Hydrostreams >> http://hydrostreamforums.com/
My Project 1979 V-King restore >> http://hydrostreamforums.com/viewtopic.php?f=9&t=2761
-
03-18-2018, 06:44 PM #35000 RPM
- Join Date
- Jul 2008
- Location
- Portland Oregon
- Posts
- 100
- Thanks (Given)
- 0
- Thanks (Received)
- 0
- Likes (Given)
- 0
- Likes (Received)
- 2
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
OK. Hoping for the same. I did the same with all the tanks / hoses, just wasn't sure what to do with the wires coming out of the control box.
-
03-18-2018, 08:02 PM #4
zip tie them out of the way and forget them
Similar Threads
-
Laser injection- wiring diagram
By capteliminator in forum Technical DiscussionReplies: 1Last Post: 03-22-2014, 02:03 PM -
wiring diagram for 7 pin cannon connector at motor//wiring to start on engine stand
By seabold in forum Technical DiscussionReplies: 9Last Post: 10-24-2013, 08:50 PM -
point in time of fuel injection, has anyone played w/ different injection points?
By mrcrsr in forum Technical DiscussionReplies: 7Last Post: 01-28-2011, 08:21 AM -
Lazer Injection wiring/amp draw?...
By mercat in forum Technical DiscussionReplies: 9Last Post: 02-11-2010, 01:56 PM