User Tag List
Thanks: 0
Results 1 to 5 of 5
Thread: Stay or melt down?
-
03-17-2018, 10:37 AM #1Junior Member
- Join Date
- Mar 2018
- Location
- Florida
- Posts
- 23
- Thanks (Given)
- 7
- Thanks (Received)
- 0
- Likes (Given)
- 1
- Likes (Received)
- 0
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
-
03-17-2018, 11:01 AM #2
That one is well done.
RockTeam Junk
No sparkling wiggles in here, only dump truck grinches.
"Screamin Heathen"
-
Dave Strong liked this post
-
03-17-2018, 11:28 AM #3Screaming And Flying!
- Join Date
- Mar 2008
- Location
- Tourist Trap, Florida
- Posts
- 14,753
- Thanks (Given)
- 381
- Thanks (Received)
- 1305
- Likes (Given)
- 5602
- Likes (Received)
- 11033
- Mentioned
- 2 Post(s)
- Tagged
- 1 Thread(s)
Charging system failure can cause that, and loose batt terminals are a contributing factor too. Do your voltage regulators have a clear potting or black potting? Clear potted regs are a big problem. Get rid of them..
83 V-King, 96 Mariner, 200 hp ff block 2.5 w/a 28p choppa
We gotta clean this liberal mess up, VOTE TRUMP TO MAGA!
Rebuild thread:
http://www.screamandfly.com/showthre...-it&highlight=
http://www.screamandfly.com/showthre...cs.&highlight=
Videos
-
Dave Strong liked this post
-
03-17-2018, 11:54 AM #4Junior Member
- Join Date
- Mar 2018
- Location
- Florida
- Posts
- 23
- Thanks (Given)
- 7
- Thanks (Received)
- 0
- Likes (Given)
- 1
- Likes (Received)
- 0
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
I'll check the regulator, thanks. I'll test the stator resistance per the manual, but yeah, doesn't look too good. Ready to sell this sucker before putting money into it.
-
03-19-2018, 09:01 AM #5
I was living the looper stator drip dream. sucked. lost an entire boating season over it.
If I don't ask any questions, I'll never learn anything.
Similar Threads
-
Melt down
By flabum1017 in forum Technical DiscussionReplies: 11Last Post: 11-09-2012, 06:58 AM -
What caused this to melt?
By K-Dawg in forum Technical DiscussionReplies: 9Last Post: 01-03-2012, 07:28 AM -
300x melt down
By carguy in forum Technical DiscussionReplies: 15Last Post: 07-12-2004, 09:23 PM -
Melt a 2.4 or not?
By Techno in forum Technical DiscussionReplies: 0Last Post: 04-09-2003, 06:34 PM -
Stop the melt down
By us1 in forum Technical DiscussionReplies: 2Last Post: 10-13-2001, 06:20 PM