User Tag List

Thanks Thanks:  0
Likes Likes:  1
Results 1 to 2 of 2
  1. 01-28-2018, 05:31 PM #1
    1978allison
    1978allison is offline Member
    Join Date
    Oct 2010
    Location
    Easley,sc
    Posts
    65
    Thanks (Given)
    0
    Thanks (Received)
    0
    Likes (Given)
    0
    Likes (Received)
    3
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)

    Inline six drive shaft

    I have an old inline six drive shaft (1978) that has some wear(grooves) above the water pump key slot about 1 inch overall height. This is something that I am not familiar with. Is this reparable? What caused the problem?
    Reply With Quote Reply With Quote
  2. 01-29-2018, 12:28 PM #2
    Dave S
    Dave S is offline Screaming And Flying!
    Join Date
    Dec 2001
    Posts
    9,502
    Thanks (Given)
    23
    Thanks (Received)
    271
    Likes (Given)
    191
    Likes (Received)
    1976
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    If the stainless insert had spun at one time it may have caused this. If not too deep n/p.
    Reply With Quote Reply With Quote
  3. Likes Mark75H liked this post
« Swept or straight skeg single outboard 24 skater 300 3- litre | 2.7 heads install, 140 compression ? »

Similar Threads

  1. Inline 6 Six 1100 110 HP Short 15 in Drive Shaft Housing
    By W2F a V-King in forum Ebay Listings and Other Internet Listings
    Replies: 1
    Last Post: 01-06-2018, 09:56 PM
  2. Cutting an inline merc drive shaft???
    By gw1250 in forum Technical Discussion
    Replies: 2
    Last Post: 02-21-2008, 09:57 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Aeromarine Research