Aftermarket trim: Panther power trim and tilt bracket opinions?

[mxz]

Looking for an aftermarket power trim and tilt for my sons Hydrostream Voodoo with an older Evinrude 50hp. I came across a Panther model 55 power trim and tilt bracket for a good price. Anyone use one of these? Opinions? Good, bad?
Thanks

[97 TWISTER]

I have one on a gw invader mod 85 Suzuki set up high enough to have prop shaft even with pad. Seems plenty strong wish it trimmed a bit faster. I did have the relay crap out this summer for the trim but not sure how old it is didn't buy new. I have had the boat into low 70's with no issues. Hope this helps

[mxz]

Thanks for the info 97 Twister.

[mn808gade]

never put that much power on one,lots of them around here on all kinds of rigs including pontoons,relays same as on newer units,but most relays podded and that requires upgrading wiring harnass.lot of older units need replacement power units.Panther now HQed in White Bear Lake MN..more info?call me daytime for compleat info terry 6123902474

[97 TWISTER]

never put that much power on one,lots of them around here on all kinds of rigs including pontoons,relays same as on newer units,but most relays podded and that requires upgrading wiring harnass.lot of older units need replacement power units.Panther now HQed in White Bear Lake MN..more info?call me daytime for compleat info terry 6123902474

Isn't this model rated for up to 250lb motor? I should have asked but I assumed he was talking about a 2cyl motor which should be fine. I realize my application is pushing the limits and don't really suggest doing many things I do lol. As always be safe, wear a good life jacket and check you rig before and after every use.