User Tag List
Thanks: 0
Results 1 to 6 of 6
Thread: Need help identifing this motor.
-
08-17-2016, 06:25 PM #1New Member
- Join Date
- Aug 2016
- Location
- San Diego
- Posts
- 4
- Thanks (Given)
- 0
- Thanks (Received)
- 0
- Likes (Given)
- 0
- Likes (Received)
- 0
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
Need help identifing this motor.
I got motor a few days ago from an older gentleman. Said his son got it for his boat. Boat got sold engine stayed behind. On the block all I can find is a Letter A. and L2264 smaller with 333 stamped over it. on valve cover 329965. Throttle linkage 129996, and on each of the 8 carbs 397479 17 FKMX, and the bottom of engine a v8 Logo stamped on linkage is a circle with a square inside and a M inside square, Circle Square M.
Was told 76 race motor, Been unable to find anything like it. Has to be some power because 8 carbs and motor is upside down so valves working opposite of what the norm is. no oil tank so must use a oilier. Thank you for any help
Thank you
ConfuzedLast edited by Confuzed; 08-18-2016 at 10:53 AM.
-
08-17-2016, 07:05 PM #2
-
08-17-2016, 07:09 PM #3
Two stroke V8 OMC, no valves(except reed valves), no valve covers
-
vnemous liked this post
-
08-18-2016, 10:48 AM #4New Member
- Join Date
- Aug 2016
- Location
- San Diego
- Posts
- 4
- Thanks (Given)
- 0
- Thanks (Received)
- 0
- Likes (Given)
- 0
- Likes (Received)
- 0
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
-
08-18-2016, 10:50 AM #5New Member
- Join Date
- Aug 2016
- Location
- San Diego
- Posts
- 4
- Thanks (Given)
- 0
- Thanks (Received)
- 0
- Likes (Given)
- 0
- Likes (Received)
- 0
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
Thank you gives me a place to start looking big bore looper this way I can make up my mind what to do with it.
-
08-19-2016, 10:51 AM #6New Member
- Join Date
- Aug 2016
- Location
- San Diego
- Posts
- 4
- Thanks (Given)
- 0
- Thanks (Received)
- 0
- Likes (Given)
- 0
- Likes (Received)
- 0
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
Thank you very much that what she is. They have one in a sandrail. I would throw it in my ranchero but not a good motor for anything but wide open throttle. I dont have a problem with that but will the judge understand???
Once again thank you
Similar Threads
-
need help identifing motor
By mountainfreik in forum Technical DiscussionReplies: 3Last Post: 08-25-2010, 08:40 AM -
Any help identifing this motor
By 97 TWISTER in forum General Boating DiscussionReplies: 15Last Post: 03-10-2010, 07:29 AM -
Identifing props
By Jacob in forum Props, Setup, and RiggingReplies: 1Last Post: 01-31-2010, 08:16 PM -
Need Help Identifing Boat
By Corwin in forum General Boating DiscussionReplies: 4Last Post: 07-04-2007, 07:10 PM -
Help Identifing an in line 6 SN.
By Tom Smyth in forum Technical DiscussionReplies: 1Last Post: 12-26-2006, 03:08 PM