User Tag List
Thanks: 0
Likes: 0
Results 1 to 3 of 3
Thread: V4 Port map
-
01-22-2013, 01:15 PM #15000 RPM
- Join Date
- Aug 2009
- Location
- Florence SC
- Posts
- 249
- Thanks (Given)
- 1
- Thanks (Received)
- 4
- Likes (Given)
- 1
- Likes (Received)
- 6
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
V4 Port map
Before everyone points me to the "9 pages" article, let me explain my question.
I am looking for a map , if such exists, w/ actual port timing in Degrees for a v4 OMC.
would prefer to be 77-79 140, or KR-15 ports.
I have the "9 pages" document & it has super information from Alan Stoker that I have used for many years.
Most of the V4 mod threads start w/ a 140 or 115 block that already have the bigger ports in them. I am starting w/ a 1984 90 hp block w/ VERY small ports.
On loopers that I have built in the past, I use a degree wheel mounted to a modified flywheel hub and place the ports @ locations in relation to TDC / BDC. This method seems to give me a more consistant port job.
Any input, comments suggestions are greatly appreciated.
LT
SC Mellonbelly Associate.
-
01-25-2013, 12:11 PM #25000 RPM
- Join Date
- Aug 2009
- Location
- Florence SC
- Posts
- 249
- Thanks (Given)
- 1
- Thanks (Received)
- 4
- Likes (Given)
- 1
- Likes (Received)
- 6
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
Come on, Somebody say something !
-
01-27-2013, 11:08 AM #3
BOO! lmao!