User Tag List
Thanks: 0
Likes: 0
Results 1 to 2 of 2
-
02-27-2011, 10:39 PM #1
removing trim ram in a 84 200 merc, single ram trim.....
got everything off/out. but the trim ram has a small pin that is supposed to be pressed/hammered out. the service manual says to remove from front to back, which i've tried a few times. It's not moving at all, i'm not sure if it's normally that hard or i'm just not hitting it that hard. I don't want to mess anything up, i've put some pb blaster on it, but it seems to not move at all. This is on a single ram trim, mid.....
1990 Viper 140 crossflow
2011 Sea Hunt 232 Ultra
1995 Laser 380
1984 Reaction 19 project.........
-
02-27-2011, 11:36 PM #2
Yes, that is correct. You just have to beat the hell out of it. I have had to drilled some of them out.