Drag pipe header

[Liberator*21]

I'm gonna give a try and i don't think it will be a problem. But I'm gonna use stainless sanitary pipe (very thin and light ) because I have a ton of it. The plate out of 12gauge stainless and maybe cut the tips at a sharp angle to add to the cool factor

Thanks again gary

Ok, I took a small clip of the motor running on the hose, can removed and running a HydroTec Tuner. The drag pipes really don't come into play until it's in the water. Right now the exhaust gases will seek the path of least resistance. Pardon my smoke, brand new motor on break-in pre-mix oil ratio.........Holy Smoke Batman...................

http://s177.photobucket.com/albums/w...rent=Motor.flv

Good luck bro...............

[mikemanic]

No matter how silly it sounds, while this as a project/experimient you did learn something, right? So I wont call it a waste of time.