3 litre alian hood conversion

[Image 21]

got a 3 liter with a alian hood done today.took a stock lower cut it down,set a alian hood base on it and started chopping and glassing,and yes its still a two piece. i think its pretty cool plus lost a few pounds.i`ll get couple more pics up when computer acts right

[Image 21]

hope to have in paint by the end of week i`ll change pics as it get completed

[Stitch King]

Did you Glass a flange on the old lowers for the Alien to bolt up to? Might want to do a final layer with epoxy instead of poly/vinyl ester. Those old lowers are a BMC/Compression Molded thermoset. For cracks Poly/vinyl ester works ok but for structural work/repairs I've experienced failures to bond to that material even when roughed up with 36 grit. Epoxy's and urethanes bond well to it however.

[Image 21]

Did you Glass a flange on the old lowers for the Alien to bolt up to?

yeah , basicly i cut about 3"of the stock lowers.then i set the pan on it with a little putty to hold it to work.next i cut out the inside of the alian pan tabbed it in with glass on the inside.on the outside i blended the two together with a ahair stran putty ,faired it out . now i`ll put a 1/2 oz mat or something on the out side to keep from cracking fair that and paint . so far about 6 hrs into it,thats with kids saying come here dad and the phone ringing.oh yeah made the pan about 1/2"taller to clear to of fly wheel cover or just take it off. oh yah thanks for the help earlier on hoods got this one for my uncle and well i adapted to my needs

[Image 21]

should have base in paint sat, pics on sunday ,any input, or is it pretty stupid what i`m doin

[Image 21]

shot the black on tonight will post pics friday of finish base

[Image 21]

well here it is hope to have hood in paint by next weekend and all on boat. any thoughts?

[afr]

looks good
did you see mine

[Image 21]

looks good
did you see mine

yeah thats great looking piece too

[afr]

we both finished about the same time
lol

[Image 21]

we both finished about the same time
lol

i still have to paint hood and put on latches, cut wire opening and put in trim switch in cowl

[afr]

i got to cut my breather holes and install the bunges and i can go to the water

[shibby1485]

nice job fellas!! wish i had seen this! altho, ven if i did, i dont have the patience or know-how to glass up the conversion.

i just stripped my 3 liter hood cowl and lowers and had them repainted and dropping it off tomorrow for some graphics.

mine ios a 3.0l 250EFI Offshore... the graphics were stupid boring and slow looking

can't beat the looks of an alien cowl tho, wish it was alot easier to get one onto mine otherwise i would have done that in a heartbeat

[Fish]

i still have to paint hood and put on latches, cut wire opening and put in trim switch in cowl

that is really good looking Image21

[Image 21]

nice job fellas!! wish i had seen this! altho, ven if i did, i dont have the patience or know-how to glass up the conversion.

i just stripped my 3 liter hood cowl and lowers and had them repainted and dropping it off tomorrow for some graphics.

mine ios a 3.0l 250EFI Offshore... the graphics were stupid boring and slow looking

can't beat the looks of an alien cowl tho, wish it was alot easier to get one onto mine otherwise i would have done that in a heartbeat

tell you what you get the pan and hood and find an extra 3 litre pan i`ll do the pan for yeah check with graynester see if he can still get that hood and pan i`ll help a brother out.its not that bad once you figure it out