2 Attachment(s)
Carburetor Emulsion Tube Alignment Question
Guys,
I've just bought an Evinrude 115 V4 (1978) on the back of a Glastron GT150 that I'm restoring. I pulled the carbs and found 3 of the 8 jets completely stopped-up. Two of the jets had been drilled out (holes too large) while everyone of them had stripped slots in the heads, so I pulled all of them using an easyout tool. I'm going to replace them all with factory new ones.
One other thing I discovered was that 1 of the 4 emulsion tubes is miss-aligned. I have attempted to rotate it, but it's not moving and I don't see them available should I bread or damage it. The question and reason for posting this is to get opinions and experienced inputs on whether this matters and if so, how do I fix/replace? I've looked and cannot find an emulsion tube listed for sale. The factory manual does not cover removal in the Fuel System section. Thanks, Gordon
This photo on the left is correct and 3 of the 4 are like this. The photo on the right is the one I'm concerned about -
Attachment 448666Attachment 448667