Are the Wizard wires better than the OEM ones that come from Mercury High performance ? I have 91 2.5 carb 245HP
any opinions?
Thank you
Joe
Printable View
Are the Wizard wires better than the OEM ones that come from Mercury High performance ? I have 91 2.5 carb 245HP
any opinions?
Thank you
Joe
If theyre the original 30 year old NGK’s, then yeah, the Wizards are better.
I have both, and they seem to be comparable except in aesthetics. I will leave it to you as far as the looks.
Chaz = thinkin, Mach was layin odds you don't have a .....> https://tse3.mm.bing.net/th?id=OIP.K...=0&w=300&h=300V.O.Meter ... And with the above statement ... you sent him to the pay window .. ;)
Great thanks everyone have a set on order.
Just use the one's from 1991 ... you'll be OK .. :thumbsup:
Better yet, I was at the junkyard a couple days ago, they were about to crush an early 70's van .. I barely had time to reach in the doghouse and grab those dry rotted wires before they became part of a little cube. Whatta waste that wouldda been ... :rolleyes:
Points, analog, digital, twin 40 amp MSD mags ... New for new, there is a wire for every application ... but that wasn't the question. :)
Stick your finger in the end of the plug cap and crank it over, each one will most likely give ya the same sensation.....:leaving:
I hate the smell of purple
wizy is typically shielded better do you need it ehh dunno.
though my last set of new merc wires ohms at 1200 with 1100-1300 being spec on that engine and one of the three was 1289. Was a touch disappointed to not see 1100-1150 for fresh ones.
Orange-Yellow not so bad ... :nonod:
Deep Blue with a White tip .... :eek: I'd rather get checked for carpal tunnel every day for a week .. :leaving:
Chaz = thinkin, I know I just jinxed myself ... sometime today the rod will meet Tungsten - and I will be the better ground .. :D
Does anyone know where to buy the NGK Hi-Performance blue ones? Or have two laying around
I sell tons of the Wizard 8.5 mm plug wires to satisfied customers . $40.00 a set plus the ride . I carry both types of ends for 280 type and standard ..
Jay @ JSRE