this is the .044 over motor that was on my Seebold.
it was sent off to Ruck for a sleeve before its last rebuild.
it has new pistons,capped wrist pins, all new bearings, new lapped 2 piece sealing rings, decked 7 peddle ( non oiler) front half,efi reed blocks with single stage reeds.
The ports are matched to 300 drag specs with behind the liner work done as well. The pistons were machined to match the transfer ports.
it has one of my worked manifolds on it with one of my spacer plates , all complimented by a set of wmh 3 pumper carbs.
It is fully dressed and topped off with an aluminum flywheel.