Another DW 28 getting close

Oscar and his crew worked some long days over the weekend and the deck was pulled this afternoon. Hull weight came out at 1250 and the deck came out at 446. A reference for those that are not familiar with hull weights, a light weight 24 skater is 1650 and there is no core on the tunnel sides to get them that way. This boat is built very stout with complete core as shown, additional running surface support added and still came out where it did. I am very happy with these results and the pride of workmanship and attention to detail that was put forth by everyone involved.

Joe
Attachment 402708Attachment 402709Attachment 402710Attachment 402711Attachment 402712Attachment 402713Attachment 402714Attachment 402715

And the two become one- I am not sure that the priest was there for the ceremony but it looks like a match made in heaven to me.

JoeAttachment 402797Attachment 402798Attachment 402799Attachment 402800

In a word, Beautiful!

I'm eager to see hull and deck flanges cut off and how you bond hull to deck . I assume you spray the seam with gelcoat and buff ?I assume you use flange to temporally align up hull and deck and then send in the smallest Mexican you have to glass hull to deck ? Then after cut off flange , glass seam outside , body work then gelcoat ?

The two molds were cut on the CNC and mate up perfect. There is minimal body work and yes they are glassed along with all of the deck rings being taped in. The liner is attached to the tunnel top and its ready for battle. The cost of building these molds and all of the patterns was substantial but as you have seen on this thread, it makes for a fast and consistent production process.

Joe

Quote:

---

Originally Posted by RADER

In a word, Beautiful!

---

Thank you Mario, we need to get a few these up on the island.
Joe

Yes we do, it really is a nice piece.

Seam work

This was mine and you cant tell where the seam is when done.

.


a big mouth and a sharp leading edge, all good qualities in a cat boat!



loverly!






.

Bad ass!!!!!

The progress that Oscar and his crew are putting into this boat for me is absolutely amazing. I really can't thank these guys enough for putting in the hours that have in the last week. They cut the flange and are marching forward so that Oscar can get to a point where he can break away for a few days to spend time with his wife and son. He and is wife just had a new baby that was premature and his esophagus was not fully developed to connect his throat and stomach. Please add he and his family in your prayers, his son will have to spend the first 4 to 6 months of his life in the hospital and undergo numerous procedures throughout the process.

Joe

Attachment 402862Attachment 402863Attachment 402864Attachment 402866Attachment 402867Attachment 402868Attachment 402869Attachment 402870Attachment 402871

Quote:

---

Originally Posted by scawd the dog

Bad ass!!!!!

---

You haven't seen anything yet. Wait until I get your ass in the drivers seat. I am going to make sure that there is a towel put down....

Joe

Quote:

---

Originally Posted by JPEROG

You haven't seen anything yet. Wait until I get your ass in the drivers seat. I am going to make sure that there is a towel put down....

Joe

---

Joe : I can't wait !!!!!!!!

Is the entire hull/ deck seam get glassed on inside ? Cant see how those tight areas can be done