This is my angry post. I hate mice. They cause fires in my garage, nests in my toolboxes. Nests in my heaters. Gotta mince them fuggers!!!
oh and I hate snow. It's a week into spring and we just got another 7" dumped on us. Ugh.
Printable View
This is my angry post. I hate mice. They cause fires in my garage, nests in my toolboxes. Nests in my heaters. Gotta mince them fuggers!!!
oh and I hate snow. It's a week into spring and we just got another 7" dumped on us. Ugh.
More angry !!!! Why does this website post my pictures upside down ?!?! They're right side up when they upload !!!
Apple?
iPhone, but the pics are straight on the phone. Once uploaded, they sometimes flip. Sometimes don't. Very weird. Must be the site! Haha
snow, snow, go away. With boat, I want to play.
Will that phone rotate a pic to keep it level when you are viewing it? It might have something to do with phone position when uploading just a thought. That snow came through here the day before, more to come in day , then to you .
Yes, I can edit them and rotate, but once rotated, it should be locked in. IDK - I'll experiment this afternoon when back on WiFi and not at work.
FMP - KEEP THAT SNOW WITH YOU PLEASE haha. The dang jet stream is my enemy right now. Guess it gives me more time to finish wiring, and get rid of some more Mice.
Unless you seal every hole, window and door opening, roof gap etc they will be back . They can make you sick so ....
Non-skid painted on inside floor- Check.
OOGA! Horn installed- Check.
Wiring complete (minus amps and speakers/sub). Check.
Splashwell drain hose installed. -Check.
Got a 13x19 stainless prop to try out cheap at the consignment shop. It has a good amount of cup at the trailing edge of the blades.
My shaft is tapered on the inside part, but the prop wasn't. I have this spacer from my last prop which was tapered, but would really stick out the prop far from the torpedo. Is this spacer needed or no?
Not sure the brand or style prop this is either.
Blades looks thick, what's the prop riding on , find a thinner blade less cup , too much drag I think , try a merc AL prop to start if you can find one.
The prop hole is straight through, no taper. The prop shaft has a taper @ the end closest to the hub, fwd side. The aluminum prop I took off, had that spacer with the tapered ID to fit the prop shaft. This stainless prop is slightly longer (hub length) than the aluminum, figured I didn't need the spacer. With the spacer, the prop has a gap between Hub & Prop. Is that Good or bad?
Attachment 341594Attachment 341595Attachment 341593Ended up using the tapered thrust washer. Little bit of a gap between hub and prop, but we'll see how it goes.
Got the middle trim piece I was missing... now need opinions on what color to paint it... Red, Black, or White ???
You can tell my brother is very enthusiastic about holding the piece up for me hahaha.
White and add some decals to finish it off.
Karsten
So are you going to be sitting on phone books or what?
Got a cheap seat for now. Going to get a nicer one later.
The white looks good, thought you had some cool decals.