Saw this on Instagram today figured I would share it.
Printable View
Saw this on Instagram today figured I would share it.
Bold project. I hope he is rewarded for his effort. Sure is a lot of weight to add.
LS motors, he is going to be running it mainly in the keys but will hit some of our runs as well.
Joe
Aluminum ls motors fully dressed for auto use is 460lbs
Same boat as this one or is this a different project?
https://www.offshoreonly.com/forums/...-bravo-1s.html
Same project-
Joe
...just saw this. steering cylinders need to be bolted at the x-demension or crankshaft centerline, not where they are. so the cylinders need to be a bit shorter then also. hard to tell from this photo though...
Yes on the steering.......as the trim cycles up/ down it has to in the right plane with the pivot point.....