MY 225 STOPPED its reg beep. i grounded temp wire.. still silence? is the buzzer in the control box? i dont think i grounded the correct way. my electrical skills are limited. its the only alarm on motor.
Printable View
MY 225 STOPPED its reg beep. i grounded temp wire.. still silence? is the buzzer in the control box? i dont think i grounded the correct way. my electrical skills are limited. its the only alarm on motor.
the buzzer should have 12v to it any time the key is on.. if it runs hot the sender grounds it and the alarm goes off.. when you first switch it on it grounds and beeps to let you know that it's working...find the buzzer , switch key on , check for 12v , ground the other side ...it should blow..if it does not , then the horn is bad....if it does , then figure out why it's not grounding..
should be in harness near key switch
If the key is in the control box warning horn should be inside, key in dash will be at ft of harness like Vnemous stated.
Dave
I assumed that because this is a High Performance boat site he would have and Incontrol shifter and a foot pedal like the rest of us.missed the control box part:DQuote:
Originally Posted by Dave Strong
81649A1 is part number if in box.
Key is in control box but horn is behind dash pretty sure black plastic disk with a blue and white wire has to be beeper. ill see if blue is 12v with key on, grounding white should energize horn. thanks guys. i cant run with alarm disabled.
ive got 3 wires onport sensor 1 says gauge other 2 seem like pairs, should i be checking the single marked gauge?Quote:
Originally Posted by BOATMANBLUES
port side, gauge means "temp gauge"... over heat is in starboard head.. single tan/blue wire.. it is tha wire you can ground to test buzzer also.. 2.5 or 3.0 motor?.. oiler still work?.. if so then it could be tha oiler warning module.. it is what makes tha buzzer test beep when key is turned on...
what motor?.. may have an OEM manual in pdf for it.. can send it to ya if I do have it..
ok grounded starboard wire horn sounded. just cant get the test beep. on start-up. beeper is behind dash, key in box, using foot throttle. 225 pmx non-oiler no modules. im 99% sure i heard a beep after rigging and turning key 1 st. time. not even sure anymore. what mystery part gives the 1 test churp? stumped....
ok grounded starboard wire horn sounded. just cant get the test beep. on start-up. beeper is behind dash, key in box, using foot throttle. 225 pmx non-oiler no modules. im 99% sure i heard a beep after rigging and turning key 1 st. time. not even sure anymore. what mystery part gives the 1 test churp? stumped....
no oiler module, all test beeps go away.. won't get anything with it gone.. jus get over temp alarm when/if that happens..
No module no test beep on start up.
Dave
I GUESS i am hearing things????? old age setting in...Quote:
Originally Posted by tlwjkw
Yep all post above are correct on the no box no beep:iagree: think nothing about the getting old situation i have things falling off me at a very rapid rate at this point in my life at 73 the outlook for future impairments looks bright :rolleyes:
thought tha same thing but my little bride says I can't hear ****....Quote:
Originally Posted by KIRCHNER
right along with bobby on tha rest of tha story.