What are some known and proven ways to add some more water temp heat to a 260 Mercury EFI, 1996 powerhead.
Thanks, Carter
hey guys, im redoing a low hour 97 225 efi and am down to the final pieces. Putting the new high pressure pump into the VST. With that being said there
Last Post By: skialot2 Today, 04:28 PMHey guys is there anything out there that will strip paint off a boat down to the gel without damaging the gel ? Thx
Last Post By: dgscroggs Today, 03:34 PMI recently bought an LTV copy built by Creative Marine. Anyone know anything about them?
Last Post By: FUJIMO Today, 02:05 PM1968 Phanton 17', vintage race hull, MERC 1999 280 hp, sportmaster fat shaft lower unit seastar pro 2 steering, seastar extreme jack plate, new wiring
Last Post By: FUJIMO Today, 02:03 PMI laugh every time I see this.
I just purchased two 1994 piranha tunnel boats .they were built for drag racing in the early days of dsra here in the south..from what I remember they
Last Post By: WaterZebra Today, 01:21 PM.
a great find , has been stored for 15 years when I found her on April 19, 2022
I know he had some friends on here,but he passed away yesterday I’ll be going down by him this week to help his wife out
Last Post By: merc1250bayliner Today, 12:04 PMHow much more performance does a 300R have over a 300X? From what I have read here they seem to have more performance
Last Post By: JPEROG Today, 11:20 AM2005 300X engines, the last and best year of these. Fat shaft lowers. Low hours - 297 & 302. 140-145 psi compression across the board on both engines
Last Post By: Voodoo1 Today, 08:25 AMWhen you just need more blades. Way more.
.
Pantera building a plug from an original 24 footer
Post a random photo thread! Add yours!
Post a random pic Thread i will Start Freeze Frame
Add yours
other forum has one of these
225 Promax Plug variance between banks
Thread Starter: JAAHello All,
Last Post By: tlwjkw Today, 06:25 PMMy engine seems to be running well and feels strong. But when I check my plugs the port bank of cylinders are brown, about what