What would you pick and why? I have not seen much on the yamahas (I kno this site is mostly Merc based tho)
Last Post By: mistah_max Today, 09:58 AM24’ Excalibur Hull and trailer Boat was originally a stern drive. The transom was filled and reinforced
The rear seat was moved back to give more
I have a pair of low hour (20ish hours) HD 300R's. 20" shaft length
Imco Side steering rams and rear Tie bar 26"
1.60 Sport masterlower
.
Rey Marino (may he rest in peace) would be very proud right about now to see his work become a world record holder
i have a question that nobody seems to know the answer. 0n an early 2.0 150 with WH27 carbs the 7/16 jet plugs. located on the sides of the carb, the
Last Post By: KIRCHNER Today, 08:19 AMScream And Fly - Long Island (youtube.com)
rondack romp 08 hydrostram (youtube.com)
slide show...bad ass
2002 225 25” FICHT
Came on a project boat
400 hours
looks very clean
Had it up and running
No spark on 2 cylinders
I laugh every time I see this.
Very nice condition mid section with trim pump and working trim sensor (when I used it last in 2022). purchased as part of a complete ProMax 225 and
Last Post By: Jkissel20 Today, 06:51 AM
15 K with trailer No Motor!!
Happy Birthday Greg. Hope it is a good one.
Rock
One of the things I found last fall is my
My thinking is it's Yamaha's 2.6 liter block. But the question is, which configuration was most reliable? Their carbed version (which you can still get
Last Post By: skialot2 Yesterday, 10:33 PM
300R sportmaster
Thread Starter: ski racer1.75 ratio Sportmaster from a 300R
Last Post By: ski racer Today, 10:11 AMabout 250 hours on it, removed and went to a Torquemaster
Shipping avalible
Located