30" mercury pro-et 4 blade (stock)
32" mercury pro-et 4 blade (stock)
both are 9.5/10 (only because they are used)
both will
Whatcha got?
Last Post By: Stevelinder Today, 09:13 AMhttps://youtu.be/4Olk5AU_tfg?t=296
Last Post By: doug7488 Today, 08:46 AMFinally picked up this 15' Delcraft tunnel built by Ron DelRosa in California. this boat set SJ and SJJ records back in the day, driven by Bob Holloway,
Last Post By: WaterZebra Today, 08:40 AMI laugh every time I see this.
One of the things I found last fall is my
Looking for two fiberglass rae seats .don't have to be perfect...just light.any out there?
Last Post By: tommytee Today, 08:04 AM
I have 2 20” offshore mids with adapter plates. Came off a 24 Skater. Yes they were used in salt water. Snouts are cut. Bushings are tight. Need
stock 280 see pictures in hulls under 20' everything you need !
Last Post By: I Belong On The Water Today, 06:34 AMMy thinking is it's Yamaha's 2.6 liter block. But the question is, which configuration was most reliable? Their carbed version (which you can still get
Last Post By: skialot2 Yesterday, 09:25 PMNice 24 Yamaha worked by Tillman. $650 shipped in US. PM me if interested.
Last Post By: StratosVT Yesterday, 08:50 PMWhat does it take to make one run on an Allison?
Are they like a 2.5 merc where it is easy to get one set of solid mounts in and the whole
What would you pick and why? I have not seen much on the yamahas (I kno this site is mostly Merc based tho)
Last Post By: Speed Jr. Yesterday, 08:09 PM
repost. 13 inch omc mod motor v-4 crossflow
Thread Starter: racervboatNew rebuilt powerhead 10 page build
Last Post By: racervboat Today, 09:28 AMNever been on a boat yet has been run on stand only.
Uses custom trim with pump in the boat.
I posted