Should say "Merc carb V- stacks. Yes I know Bob's sell them, I even know that someone is selling new ones on fee-bay. Like the solid mounts I was
Last Post By: MrG Today, 08:54 AMI've got a pair of 250 efis, CXXL 0g62xxx and cxl(converted to xxl) 0g68xxx. I've been chasing my tail for months on one building rpms faster getting
Last Post By: Aaronhl Today, 08:45 AMFinally picked up this 15' Delcraft tunnel built by Ron DelRosa in California. this boat set SJ and SJJ records back in the day, driven by Bob Holloway,
Last Post By: WaterZebra Today, 08:42 AMLooking for 250 XS (or 300 XS) with Sportmaster lower with low hrs + plus the rigging. 20" mid RH drive. Would prefer fresh water motor, but clean
Last Post By: crabbait Today, 08:14 AMLooking for a crap crank, Whole, half, quarter, 1/16th???? Just the top that is above the first counterweight with the bearing race/journal.
What would you pick and why? I have not seen much on the yamahas (I kno this site is mostly Merc based tho)
Last Post By: AlliStan Today, 05:48 AMMarketplace - 1986 Hydrostream Hustler (catamaran/tunnel hull) | Facebook
I have a fresh water ros clamp and trim bracket, no pump or hoses !! $750 plus shipping.
Last Post By: riverracer2 Yesterday, 09:12 PM1992 21 for sale This is a nice very clean boat. Hull has been notched and vented, Livorsi gauges, chart plotter gps, hot foot,  jack plate, and
Last Post By: Ryan mcc Yesterday, 08:58 PMMercury 150 Horsepower Outboard Motor
Power trim and tilt.
Very Good Condition. Runs Great. I will start and run it on the stand to demo it.
Very nice condition mid section with trim pump and working trim sensor (when I used it last in 2022). purchased as part of a complete ProMax 225 and
Last Post By: Jkissel20 Yesterday, 07:47 PMHi all. Does anyone know what the "industry" part is for the optimax air injector connectors? It's merc part number 879346A51 or 879346A49 but
Last Post By: boostalmighty Yesterday, 05:58 PMI expect quite a few here have seen this photo of a one off CVX 20 Surface drive from back in the 70's.
I know nothing about
10 spline Mercury chopper
Thread Starter: RoflhatQuicksilver 10 3/8 x 18p Chopper. 10 spline prop to fit 20-35hp although can be rehubbed to 13 spline to fit 40-70hp engines. Good condition, some wear
Last Post By: MrG Today, 08:58 AM