Three times a charm so they say. As of today the hull sits bare, cap separated, all core and transom removed. Layup is going to be balsa core set in ATC
Last Post By: LakeFever Today, 12:25 PMPowerhead is a 2008 200XS SST Gen 2 with approximately 100 hours on it. Will get accurate reading from DDT. Has Mad EFI billet intake velocity stack,
Last Post By: Onetime Today, 12:25 PMThe title pretty much says it all.
I've got a garden variety 1988, 2:1 lower like about a million others out there. The skeg is ground down
New member here from McHenry, IL thanks for the add!
I just picked up my first pleasure boat (I currently have a little aluminum row/tiller
A sad state of affairs; regarding a deliberate callous and pompous disregard for upkeeping the beauty of nature.
This act and acts like this are
In need of an alien cowl skirt if anyone has a spare they will part ways with. Let me know thanks
Last Post By: Greg G Today, 11:54 AMhello,
I have a sportjet motor 2.5l v6 with the 8pin merc plug on it. Id like to test this on a stand before I drop it in the boat. I have
What are the pros and cons of foam decking, like SeaDek, for a performance river boat? Is it heavier than carpet?
Thanks in advance.
I laugh every time I see this.
Post a random photo thread! Add yours!
Post a random pic Thread i will Start Freeze Frame
Add yours
other forum has one of these
2010 Evinrude E-Tech, H.O., 200HP Outboard. Runs well. Compression is 1-125, 2-125, 3-130, 4-125, 5-130, 6-125.
Controls are available as well.
2011 stv euroski (full throttle)
pristine condition
orginal 2.5l efi 280 ros never been rebuilt very low original hours
ecu tunned
Recently serviced by Tommy Dunn. Replaced anything that needed attention. Will post pics this weekend. $2,100 plus shipping.
Last Post By: rjdubiel Today, 07:38 AMHello,
I just finished assembling the reed assemblies on my 210 Sportjet motor. I put Chris Carson Reeds and stuffers in. I used the existing
Can the seals be replaced in the plastic blocks that close off the top of the lower?
Thread Starter: pcrussell50So I have several of those plastic blocks with the oil seals in them, that seal off the top of the V6 lower units.
Last Post By: pcrussell50 Today, 12:55 PMBut I also have a an