Is the gasket between carb and intake supposed to cover this hole in pic #1? In Pic #2 the the mixture screw is at the other end and in the middle there
Last Post By: skialot2 Today, 03:46 PMTry to figure out why my 200hp merc is overheating, This is the second powerhead and both seem to do the same thing, I got a better run today with the
Last Post By: pcrussell50 Today, 02:52 PMHey guys I’m looking for some oversized pistons to rebuild a pair of Suzuki DF 150 4t engines and came up empty on eBay. Was wondering if anyone knows
Last Post By: pcrussell50 Today, 02:38 PMI laugh every time I see this.
Hi,
Bought an Exocet 23 (piranha hull with phantom deck) and I put a 300 R, 1.75 TM, on it (not an SM, no hydraulic jackplate on it).
I have several Mercury Optimax outboards available:
One (1) freshly rebuilt 250XS Gold Block (20") w/TM @ $9000
One (1) freshly rebuilt
Post a random photo thread! Add yours!
Post a random pic Thread i will Start Freeze Frame
Add yours
other forum has one of these
What are the pros and cons of foam decking, like SeaDek, for a performance river boat? Is it heavier than carpet?
Thanks in advance.
Bobs PN 201-102xxx
Bigfoot model: dual hose bigfoot
Bought back in 2014, got put into long term storage
Original box etc...epoxy
This World is in their past now ... peace be you with ...
2011 stv euroski (full throttle)
pristine condition
orginal 2.5l efi 280 ros never been rebuilt very low original hours
ecu tunned
Carbs are complete, less jets and recently rebuilt.
These are the mid bores.
$500 TYD in the lower 48.
20” can,
Gidday guys.
Years ago there was a magazine article (Bass & Walleye?), where they did a heap of aftermarket upgrades to an Evinrude
Yamato outboard
Thread Starter: gem56I,m looking for parts Yamato Model 80
Last Post By: gem56 Today, 03:50 PMCan anyone help ?