2005 28 skater , carbon Kevlar boat 2018 300xs motors with about 70hours brand new Zieger steering , tanks done at skater , new transom built for 450s,
Last Post By: JPEROG Yesterday, 11:14 PMIm not up to speed on steering wheel trim switch , owned 30 boats , this is the first with foot throttle . Looking for decent , not complicated and cheap
Last Post By: skialot2 Yesterday, 11:11 PMMy thinking is it's Yamaha's 2.6 liter block. But the question is, which configuration was most reliable? Their carbed version (which you can still get
Last Post By: Mark Poole ModVP Yesterday, 10:06 PM1989 21’ Original Factory Twin Skater
1996 Mercury 2.5 EFI 260hp outboards (low hours, wizard pistons, Brucatos, ported, etc..)
Sportmaster
Happy Birthday Greg. Hope it is a good one.
Rock
1990 Evinrude 300 V8 short shaft with open exhaust. Motor is in very good condition and is a fresh water motor. Asking $4500. Not sure how to post
Last Post By: seahorsemax Yesterday, 08:33 PMI have a like new propellor shaft & bearing carrier with roughly 10 hours of use. They were removed from my 2023 4.2l SHO. I have installed a fat-shaft
Last Post By: X-DEWAR-X Yesterday, 08:16 PMI laugh every time I see this.
$80 plus shipping
Last Post By: engineermike Yesterday, 06:14 PM.
a great find , has been stored for 15 years when I found her on April 19, 2022
I have several Mercury Optimax outboards available:
One (1) freshly rebuilt 250XS Gold Block (20") w/TM @ $9000
One (1) freshly rebuilt
just wondering if we could get people to post pics of little boats .would love to see pics of smaller cat's , tunnel's,hydroplanes, v's, or any type of
Last Post By: slow_bloke Yesterday, 02:03 PM.
Rey Marino (may he rest in peace) would be very proud right about now to see his work become a world record holder
1992 21 for sale This is a nice very clean boat. Hull has been notched and vented, Livorsi gauges, chart plotter gps, hot foot,  jack plate, and
Last Post By: Ryan mcc Yesterday, 01:32 PM
Faria Tach with idiot lights only for OMC?
Thread Starter: DieselDoodOk, so I'm getting ready to put my boat back on the water finally after a lame but long winter.
Last Post By: PanRonnie Yesterday, 11:45 PMOne of the things I found last fall is my