I have an older friend that has a 1986 Johnson 70Hp three cylinder that does not have power trim. Can another trim unit from another OMC unit be added
Last Post By: Paul Vaillancourt Today, 10:49 AMHey guys I am in need of a shipping crate for a sportscaster LU. I have made them before but that isn't an option right now. Does anyone have one they
Last Post By: bill mason Today, 10:45 AMThe SODA Spring Showdown is a little over a week away! Lake Eustis is such an awesome location for a race. Actually, I think it's one of the best. I
Last Post By: VkingMike Today, 09:54 AMFinally picked up this 15' Delcraft tunnel built by Ron DelRosa in California. this boat set SJ and SJJ records back in the day, driven by Bob Holloway,
Last Post By: Tom Smyth Today, 09:41 AMI get all the Hemmings car magazines. In one of them this month, someone lists all the crap cars that he was happy to sell.
Boats? I've
1989 21’ Original Factory Twin Skater
1996 Mercury 2.5 EFI 260hp outboards (low hours, wizard pistons, Brucatos, ported, etc..)
Sportmaster
Quicksilver 10 3/8 x 18p Chopper. 10 spline prop to fit 20-35hp although can be rehubbed to 13 spline to fit 40-70hp engines. Good condition, some wear
Last Post By: MrG Today, 08:58 AMShould say "Merc carb V- stacks. Yes I know Bob's sell them, I even know that someone is selling new ones on fee-bay. Like the solid mounts I was
Last Post By: MrG Today, 08:54 AMI've got a pair of 250 efis, CXXL 0g62xxx and cxl(converted to xxl) 0g68xxx. I've been chasing my tail for months on one building rpms faster getting
Last Post By: Aaronhl Today, 08:45 AMLooking for 250 XS (or 300 XS) with Sportmaster lower with low hrs + plus the rigging. 20" mid RH drive. Would prefer fresh water motor, but clean
Last Post By: crabbait Today, 08:14 AMLooking for a crap crank, Whole, half, quarter, 1/16th???? Just the top that is above the first counterweight with the bearing race/journal.
What would you pick and why? I have not seen much on the yamahas (I kno this site is mostly Merc based tho)
Last Post By: AlliStan Today, 05:48 AM
Leave can in - or take out
Thread Starter: rvahaGetting ready to put my 2.4 back together after Jim Ruck finishes it. Have stripped it all the way and painted the lower, mid, and cowling with Imron.
Last Post By: Aaronhl Today, 11:18 AM