Page 8 of 14 FirstFirst 1 2 3 4 5 6 7 8 9 10 11 12 13 14 LastLast
Threads 281 to 320 of 536

Forum: Technical Discussion

The place for mechanics, racers, governing body officials, tech-talk junkies, or anyone seeking engine-related technical help.

Sponsored by: Chris Carson's Marine/CCMS Custom Reeds

  1. Exclamation Sticky Thread Sticky: New low cost ECU alternative!

    Started by Tony Brucato, 07-21-2006 08:51 AM
    4 Pages
    1 2 3 4
    • Replies: 50
    • Views: 74,157
    05-07-2019, 12:10 AM Go to last post
  2. Sticky Thread Sticky: Alisyn Oil Promotion - Free Shipping On All Orders!

    Started by Scream And Fly, 02-03-2006 04:03 PM
    5 Pages
    1 2 3 4 5
    • Replies: 63
    • Views: 71,716
    04-30-2019, 06:19 AM Go to last post
  1. talk about carb throttle plates with holes in them

    Started by eli, 06-23-2019 03:51 PM
    • Replies: 11
    • Views: 430
    07-05-2019, 06:36 AM Go to last post
  2. OMC lower died. Info needed pls.

    Started by PaulO, 06-30-2019 07:56 PM
    • Replies: 7
    • Views: 317
    07-04-2019, 05:15 PM Go to last post
  3. Mercury Tech: Rinda Technologies, Techmate pro diagnostic tool?

    Started by Tinbanger1979, 07-04-2019 07:51 AM
    • Replies: 4
    • Views: 528
    07-04-2019, 03:03 PM Go to last post
    • Replies: 1
    • Views: 1,146
    07-04-2019, 11:53 AM Go to last post
  4. Mercury Tech: Trim sender part number - Mercury 150 Pro Max ss

    Started by aeneas, 07-01-2019 02:08 PM
    2 Pages
    1 2
    • Replies: 20
    • Views: 1,082
    07-04-2019, 10:52 AM Go to last post
  5. Lightbulb Mercury Tech: hot engine, 2.5 fishing motor offshore conversion

    Started by 1981super, 07-02-2019 09:46 AM
    • Replies: 2
    • Views: 407
    07-04-2019, 09:20 AM Go to last post
  6. Seal on driveshaft on top of impeller housing?

    Started by DangerNewb, 07-02-2019 06:29 AM
    • Replies: 11
    • Views: 481
    07-03-2019, 12:24 PM Go to last post
  7. Mercury Tech: Mechanical water pressure kit.

    Started by LONGPOND-RAY, 07-02-2019 04:26 PM
    • Replies: 5
    • Views: 316
    07-02-2019, 11:04 PM Go to last post
  8. How to verify tach?

    Started by strat250, 07-01-2019 08:22 AM
    • Replies: 2
    • Views: 214
    07-02-2019, 06:19 PM Go to last post
  9. Mercury Tech: slowly dies at idle, primer bulb goes soft

    Started by pcrussell50, 07-30-2017 04:11 PM
    2 Pages
    1 2
    • Replies: 19
    • Views: 717
    07-02-2019, 05:04 PM Go to last post
  10. 1981 Custom Race Catamaran

    Started by Corysprouts84, 07-01-2019 04:20 AM
    2 Pages
    1 2
    • Replies: 21
    • Views: 559
    07-02-2019, 01:43 PM Go to last post
  11. Cranking boat in gear

    Started by CMA, 06-30-2019 08:48 PM
    • Replies: 7
    • Views: 590
    07-02-2019, 11:33 AM Go to last post
  12. 94,2.5. Twins,lost rpm's, regains when push choke

    Started by wfowahoo, 07-01-2019 08:00 PM
    • Replies: 3
    • Views: 739
    07-02-2019, 12:51 AM Go to last post
  13. Mercury Tech: 1991 2.5 245 HP cutting out at high speed.

    Started by MERCURY#1, 06-19-2019 08:15 PM
    • Replies: 7
    • Views: 384
    07-01-2019, 08:37 PM Go to last post
  14. 15 inch mid torque spec

    Started by Whaaaaat, 07-01-2019 03:51 PM
    • Replies: 3
    • Views: 182
    07-01-2019, 07:24 PM Go to last post
  15. OMC Tech: Looper, which head gaskets for Baker heads?

    Started by Captaincj, 07-01-2019 08:55 AM
    • Replies: 7
    • Views: 344
    07-01-2019, 04:16 PM Go to last post
  16. Ride Guide Question...

    Started by putt-putt, 06-30-2019 09:31 AM
    • Replies: 4
    • Views: 278
    07-01-2019, 03:52 PM Go to last post
  17. Plastic weld trigger arm?

    Started by wakepics, 06-21-2019 02:11 PM
    2 Pages
    1 2
    • Replies: 16
    • Views: 723
    07-01-2019, 12:48 PM Go to last post
  18. 225 EFI stumbles at the top end

    Started by vbtravisd, 07-01-2019 09:00 AM
    • Replies: 0
    • Views: 238
    07-01-2019, 09:00 AM Go to last post
  19. Mercury Tech: Building Merc 2.0L V6 - Which Bolts To Replace and Not Reuse?

    Started by Gordon02, 07-01-2019 01:21 AM
    • Replies: 3
    • Views: 870
    07-01-2019, 06:40 AM Go to last post
  20. Merc 175 xri timing?

    Started by Tagg, 06-30-2019 10:59 PM
    • Replies: 4
    • Views: 654
    07-01-2019, 06:14 AM Go to last post
  21. 2.4 200 rev limiter?

    Started by 2015Duramax, 06-30-2019 07:39 PM
    • Replies: 1
    • Views: 172
    07-01-2019, 12:03 AM Go to last post
  22. Stuffed the stuffers today

    Started by ivlakeman, 06-27-2019 07:27 PM
    • Replies: 2
    • Views: 767
    06-30-2019, 11:59 PM Go to last post
  23. Merc single ram trim rebuild question

    Started by lbhsbz, 06-30-2019 07:20 PM
    • Replies: 1
    • Views: 335
    06-30-2019, 08:19 PM Go to last post
  24. Mercury Tech: Wire gauge for mercury trim pump

    Started by checkmate45, 06-30-2019 02:12 PM
    • Replies: 2
    • Views: 151
    06-30-2019, 03:58 PM Go to last post
  25. A question about octane and compression

    Started by BOWSER, 06-29-2019 06:20 AM
    • Replies: 12
    • Views: 834
    06-30-2019, 12:22 PM Go to last post
  26. Mercury Tech: Power Trim Pads For Swivel Bracket

    Started by Gordon02, 06-30-2019 08:24 AM
    • Replies: 2
    • Views: 126
    06-30-2019, 10:56 AM Go to last post
  27. Sportmaster lower rebuilds

    Started by Blown Up, 06-28-2019 09:46 AM
    • Replies: 6
    • Views: 384
    06-29-2019, 11:50 AM Go to last post
  28. Temp for 250 Pro XB

    Started by jrspop, 06-28-2019 09:57 AM
    • Replies: 6
    • Views: 270
    06-28-2019, 08:19 PM Go to last post
  29. Mercury Tech: Tapping head for water temp sensor

    Started by tristanlee85, 06-26-2019 09:23 PM
    • Replies: 2
    • Views: 686
    06-28-2019, 06:16 PM Go to last post
  30. v4 cross flow ignition

    Started by ssv170, 05-07-2019 12:20 PM
    3 Pages
    1 2 3
    • Replies: 44
    • Views: 1,006
    06-28-2019, 03:19 PM Go to last post
  31. Mercury Tech: Drilled Exhaust - Real World Results and Weigh-In On Benefits

    Started by Gordon02, 06-20-2019 10:56 PM
    4 Pages
    1 2 3 4
    • Replies: 49
    • Views: 2,530
    06-28-2019, 02:31 PM Go to last post
  32. 25 inch mid section vs a 20 inch mid section

    Started by maineidyl, 01-29-2019 10:36 PM
    • Replies: 10
    • Views: 1,684
    06-27-2019, 10:22 PM Go to last post
  33. Mercury Tech: 2012 Mercury 20hp 4-Stroke Fuel Problem

    Started by TODD_TN, 06-26-2019 08:38 PM
    • Replies: 1
    • Views: 315
    06-27-2019, 07:14 PM Go to last post
  34. Mercury optimax pro xs question

    Started by Silvershiner, 06-26-2019 08:45 PM
    • Replies: 4
    • Views: 538
    06-27-2019, 04:08 PM Go to last post
  35. Mercury Question

    Started by Stricer0204, 06-24-2019 12:13 PM
    • Replies: 3
    • Views: 664
    06-26-2019, 12:35 PM Go to last post
  36. 1989 Mercury 175 cooling question

    Started by noots, 06-24-2019 07:21 PM
    • Replies: 8
    • Views: 190
    06-26-2019, 10:16 AM Go to last post

Page 8 of 14 FirstFirst 1 2 3 4 5 6 7 8 9 10 11 12 13 14 LastLast

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 75 views
Hot thread with unread posts
More than 15 replies or 75 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Spinelli Props