Page 1 of 9 1 2 3 4 5 6 7 8 9 LastLast
Threads 1 to 40 of 356

Forum: Technical Discussion

The place for mechanics, racers, governing body officials, tech-talk junkies, or anyone seeking engine-related technical help.

Sponsored by: Chris Carson's Marine/CCMS Custom Reeds

  1. Exclamation Sticky Thread Sticky: New low cost ECU alternative!

    Started by Tony Brucato, 07-21-2006 08:51 AM
    4 Pages
    1 2 3 4
    • Replies: 50
    • Views: 76,748
    05-07-2019, 12:10 AM Go to last post
  2. Sticky Thread Sticky: Alisyn Oil Promotion - Free Shipping On All Orders!

    Started by Scream And Fly, 02-03-2006 04:03 PM
    5 Pages
    1 2 3 4 5
    • Replies: 63
    • Views: 74,633
    04-30-2019, 06:19 AM Go to last post
  1. Tps laser help

    Started by KIRCHNER, Yesterday 07:10 PM
    • Replies: 13
    • Views: 210
    Today, 06:17 PM Go to last post
  2. 2.5 150 too cold at idle?

    Started by Blacknsilvr, 09-26-2019 09:07 PM
    3 Pages
    1 2 3
    • Replies: 41
    • Views: 1,237
    Today, 05:33 PM Go to last post
  3. Mercury V6 School for lower units

    Started by LakeFever, 07-24-2018 08:07 AM
    4 Pages
    1 2 3 4
    • Replies: 49
    • Views: 2,085
    Today, 05:14 PM Go to last post
  4. Newb 2.5 electronics question

    Started by ShadowFlier, 11-17-2019 08:06 PM
    • Replies: 6
    • Views: 325
    Today, 07:34 AM Go to last post
  5. 2.5 Piston Mods

    Started by tabme, 11-16-2019 08:44 AM
    • Replies: 9
    • Views: 560
    Yesterday, 11:37 PM Go to last post
  6. Gear case Bearing Swap

    Started by Hydrodreams, 11-17-2019 07:43 AM
    • Replies: 6
    • Views: 404
    Yesterday, 08:57 PM Go to last post
  7. Welding Cast Alum - mid section -- New Hampshire

    Started by race30, 07-11-2019 09:33 AM
    2 Pages
    1 2
    • Replies: 15
    • Views: 974
    Yesterday, 08:40 PM Go to last post
  8. Question No power under load

    Started by Warmstrong, 11-09-2019 12:14 AM
    4 Pages
    1 2 3 4
    • Replies: 50
    • Views: 1,171
    Yesterday, 05:38 PM Go to last post
  9. Red face OMC Tech: Building a dependable 56ci tripple with some "extra"

    Started by clubmate777, 10-16-2019 01:39 PM
    2 Pages
    1 2
    • Replies: 24
    • Views: 856
    Yesterday, 12:33 PM Go to last post
  10. Timing Indicator Question

    Started by TNRoostertail, 11-18-2019 09:51 AM
    • Replies: 6
    • Views: 433
    11-18-2019, 07:16 PM Go to last post
  11. Mercury Tech: 2.4 Laser a little down on power (since upgrades) - timing method?

    Started by gmacrae, 11-17-2019 10:09 PM
    • Replies: 7
    • Views: 613
    11-18-2019, 02:42 PM Go to last post
  12. Fuel pump pressure

    Started by Gorilla0178, 02-21-2019 10:42 PM
    • Replies: 11
    • Views: 1,514
    11-18-2019, 10:22 AM Go to last post
  13. 85 black max 200 dva results - bad trigger?

    Started by Fstarockr, 10-31-2019 09:58 PM
    • Replies: 12
    • Views: 905
    11-18-2019, 12:39 AM Go to last post
  14. Cylinder Head Machine Question

    Started by TNRoostertail, 11-13-2019 10:17 AM
    2 Pages
    1 2
    • Replies: 16
    • Views: 733
    11-17-2019, 11:33 AM Go to last post
  15. OMC Tech: 3.0 johnson cranking RPM

    Started by Gorilla0178, 09-30-2019 03:51 PM
    2 Pages
    1 2
    • Replies: 28
    • Views: 1,054
    11-17-2019, 10:25 AM Go to last post
  16. 2.4 powerhead trnsplant question

    Started by KIRCHNER, 11-03-2019 04:50 PM
    4 Pages
    1 2 3 4
    • Replies: 52
    • Views: 854
    11-16-2019, 12:01 PM Go to last post
  17. Unhappy Honda 150hp, 4 stroke

    Started by Trompie, 11-07-2019 08:09 AM
    • Replies: 5
    • Views: 601
    11-16-2019, 08:54 AM Go to last post
  18. 200 Black Max Low Water Pressure

    Started by TNRoostertail, 10-28-2019 04:50 PM
    8 Pages
    1 2 3 4 5 6 7 8
    • Replies: 112
    • Views: 1,892
    11-15-2019, 09:43 PM Go to last post
  19. 2.4 on 2.5

    Started by tabme, 11-14-2019 07:40 PM
    • Replies: 8
    • Views: 809
    11-15-2019, 10:44 AM Go to last post
  20. Need Top Pin Piston Explained

    Started by TNRoostertail, 10-29-2019 01:31 PM
    2 Pages
    1 2
    • Replies: 16
    • Views: 1,100
    11-14-2019, 08:00 PM Go to last post
  21. Swapout

    Started by berdes, 11-12-2019 02:15 PM
    3 Pages
    1 2 3
    • Replies: 33
    • Views: 524
    11-14-2019, 06:09 PM Go to last post
  22. Has anyone installed a nose cone on a verado?

    Started by 2.5-21, 11-11-2019 10:28 PM
    • Replies: 7
    • Views: 487
    11-14-2019, 05:40 PM Go to last post
  23. Merc 225 efi gray and brown sludge.

    Started by Seanj85, 11-04-2019 03:36 PM
    2 Pages
    1 2
    • Replies: 24
    • Views: 628
    11-14-2019, 04:24 PM Go to last post
  24. Mercury 260 block weld question

    Started by Tla, 11-11-2019 09:58 PM
    • Replies: 6
    • Views: 469
    11-14-2019, 06:20 AM Go to last post
  25. Mercury Tech: Mid 1980''s 200up. 2.4 mercury

    Started by buzmacdowell, 11-12-2019 06:47 PM
    • Replies: 4
    • Views: 258
    11-13-2019, 09:56 AM Go to last post
  26. Flywheel problems

    Started by Benge, 11-13-2019 05:21 AM
    • Replies: 4
    • Views: 281
    11-13-2019, 07:07 AM Go to last post
  27. Block information

    Started by tabme, 11-12-2019 08:44 PM
    • Replies: 1
    • Views: 421
    11-12-2019, 09:08 PM Go to last post
  28. 250 xs lanier custom

    Started by Brantley, 11-11-2019 06:33 PM
    • Replies: 10
    • Views: 474
    11-12-2019, 09:04 PM Go to last post
  29. Verado Power Steering Bypass

    Started by 99fxst99, 11-12-2019 01:52 PM
    • Replies: 2
    • Views: 238
    11-12-2019, 02:47 PM Go to last post
  30. Mercury Tech: 200 merc 2.4 jetting

    Started by JoshKeller, 11-01-2019 03:21 PM
    4 Pages
    1 2 3 4
    • Replies: 57
    • Views: 886
    11-12-2019, 11:13 AM Go to last post
  31. Early Model 2.0 Carb Questions

    Started by TNRoostertail, 11-11-2019 10:00 AM
    • Replies: 1
    • Views: 206
    11-12-2019, 09:29 AM Go to last post
  32. Flashed 4 stroke

    Started by 65gamblerman, 11-01-2019 08:05 AM
    3 Pages
    1 2 3
    • Replies: 36
    • Views: 1,231
    11-11-2019, 06:09 PM Go to last post
  33. Wmv 18 carbs

    Started by Merc 2.5, 10-29-2019 05:36 PM
    3 Pages
    1 2 3
    • Replies: 43
    • Views: 1,531
    11-10-2019, 09:54 PM Go to last post
  34. merc v-6 gearcase id

    Started by racervboat, 11-09-2019 09:06 AM
    • Replies: 7
    • Views: 352
    11-10-2019, 10:40 AM Go to last post
  35. Timing Instructions

    Started by seansbaja1982, 11-09-2019 09:24 PM
    • Replies: 2
    • Views: 807
    11-10-2019, 10:34 AM Go to last post
  36. T Master Gen1 &2 differences for promax3.0

    Started by skeeter91, 11-08-2019 10:02 AM
    • Replies: 2
    • Views: 306
    11-09-2019, 07:59 AM Go to last post
  37. HPDI injector gasket removal

    Started by sailnaked6842, 11-08-2019 08:27 PM
    • Replies: 2
    • Views: 553
    11-09-2019, 12:33 AM Go to last post

Page 1 of 9 1 2 3 4 5 6 7 8 9 LastLast

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 75 views
Hot thread with unread posts
More than 15 replies or 75 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Spinelli Props