Page 1 of 7 1 2 3 4 5 6 7 LastLast
Threads 1 to 40 of 255

Forum: Technical Discussion

The place for mechanics, racers, governing body officials, tech-talk junkies, or anyone seeking engine-related technical help.

Sponsored by: Chris Carson's Marine/CCMS Custom Reeds

  1. Exclamation Sticky Thread Sticky: New low cost ECU alternative!

    Started by Tony Brucato, 07-21-2006 08:51 AM
    5 Pages
    1 2 3 4 5
    • Replies: 74
    • Views: 113,785
    09-20-2020, 11:40 AM Go to last post
  2. Sticky Thread Sticky: Alisyn Oil Promotion - Free Shipping On All Orders!

    Started by Scream And Fly, 02-03-2006 04:03 PM
    5 Pages
    1 2 3 4 5
    • Replies: 73
    • Views: 112,260
    08-15-2020, 04:04 PM Go to last post
  1. Bearing Carrier Retainer Wrench

    Started by caymanfastes, 09-28-2022 12:40 AM
    • Replies: 8
    • Views: 638
    Yesterday, 04:35 PM Go to last post
  2. Lower unit oil change best practice or not

    Started by 4Speed, Yesterday 08:33 AM
    • Replies: 3
    • Views: 216
    Yesterday, 11:30 AM Go to last post
  3. 150 Mercury XRI no power and hard start

    Started by Nuckolsn, 06-04-2022 04:46 PM
    7 Pages
    1 2 3 4 5 6 7
    • Replies: 93
    • Views: 3,650
    09-28-2022, 11:15 PM Go to last post
  4. Merc 280 water pump and impeller

    Started by NeedlesRat, 06-16-2019 04:27 PM
    • Replies: 4
    • Views: 540
    09-27-2022, 07:39 PM Go to last post
  5. Exclamation Planned Site Offline Maintenance Monday

    Started by Scream And Fly, 09-24-2022 09:51 PM
    • Replies: 0
    • Views: 132
    09-24-2022, 09:51 PM Go to last post
  6. First run of a 2.4L after rebuild

    Started by paradak, 09-24-2022 09:25 AM
    • Replies: 4
    • Views: 527
    09-24-2022, 02:09 PM Go to last post
  7. Water impeller kit for 1980 200hp

    Started by Daygotires, 09-24-2022 12:24 PM
    • Replies: 1
    • Views: 121
    09-24-2022, 12:35 PM Go to last post
  8. slipped fly wheel

    Started by redsnapper386, 09-07-2022 08:49 AM
    • Replies: 9
    • Views: 712
    09-24-2022, 11:35 AM Go to last post
  9. Bore Scope Recommendation

    Started by MattGreen, 09-21-2022 10:16 AM
    • Replies: 2
    • Views: 659
    09-24-2022, 10:08 AM Go to last post
    • Replies: 5
    • Views: 733
    09-24-2022, 08:39 AM Go to last post
  10. 300x Throttle position sensor

    Started by Wild Bill, 09-16-2022 10:08 AM
    • Replies: 1
    • Views: 204
    09-24-2022, 08:36 AM Go to last post
  11. V6 Powerhead Studs Question

    Started by 86brown, 09-20-2022 08:35 PM
    2 Pages
    1 2
    • Replies: 15
    • Views: 1,478
    09-23-2022, 11:57 PM Go to last post
  12. Ngk buhw

    Started by michael lang, 09-08-2022 05:12 PM
    2 Pages
    1 2
    • Replies: 17
    • Views: 604
    09-23-2022, 11:20 PM Go to last post
  13. Mercury Tech: If you've only a rectifier and no regulator, what voltmeter behavior to expect?

    Started by pcrussell50, 09-02-2022 10:35 AM
    3 Pages
    1 2 3
    • Replies: 31
    • Views: 2,301
    09-23-2022, 07:25 PM Go to last post
  14. Help new 200 problem

    Started by austen2019, 09-11-2022 07:41 PM
    • Replies: 12
    • Views: 967
    09-23-2022, 01:03 PM Go to last post
  15. Lean sneeze Mercury 3.0 HELP Pls - 1998 250 efi

    Started by sdriche, 09-20-2022 08:43 PM
    • Replies: 12
    • Views: 993
    09-23-2022, 09:28 AM Go to last post
  16. 1980 merc 200 trim and tilt question

    Started by Daygotires, 09-22-2022 06:40 PM
    • Replies: 1
    • Views: 287
    09-22-2022, 08:26 PM Go to last post
  17. Setting ring gap on home honed pistons.

    Started by martythemad, 09-19-2022 11:30 AM
    • Replies: 6
    • Views: 889
    09-22-2022, 02:47 PM Go to last post
  18. merc 2.5 injectors

    Started by gguertin145, 09-27-2019 07:39 PM
    15 Pages
    1 2 3 4 5 6 7 8 9 10 ... 15
    • Replies: 214
    • Views: 18,868
    09-22-2022, 01:21 PM Go to last post
  19. Trim Switch DTS Panel Mount

    Started by Wayne Cammidge, 09-18-2022 02:38 AM
    • Replies: 3
    • Views: 490
    09-21-2022, 09:02 AM Go to last post
  20. Mercury Tech: 1987 2.0l 150 want to change from rectifier to regulator

    Started by pcrussell50, 08-09-2019 08:59 PM
    2 Pages
    1 2
    • Replies: 25
    • Views: 6,107
    09-21-2022, 01:31 AM Go to last post
  21. Mercury Tech: re-use needle bearings @ wrist pin?

    Started by LakeFever, 09-19-2022 11:48 AM
    • Replies: 11
    • Views: 1,046
    09-20-2022, 06:17 PM Go to last post
  22. Mercury top vs. bottom guided piston question

    Started by TODD_TN, 07-10-2016 04:50 PM
    • Replies: 9
    • Views: 2,107
    09-20-2022, 06:08 PM Go to last post
  23. Tpi

    Started by 65gamblerman, 09-20-2022 11:19 AM
    • Replies: 1
    • Views: 71
    09-20-2022, 11:31 AM Go to last post
  24. Question Short shaft in line merc???

    Started by Chevss09, 09-20-2022 11:19 AM
    • Replies: 0
    • Views: 94
    09-20-2022, 11:19 AM Go to last post
    • Replies: 1
    • Views: 197
    09-19-2022, 08:15 PM Go to last post
    • Replies: 10
    • Views: 813
    09-19-2022, 06:45 PM Go to last post
  25. Mercury Tech: 2.5L Crankshafts

    Started by Liberator*21, 09-14-2022 06:22 AM
    • Replies: 9
    • Views: 859
    09-19-2022, 10:21 AM Go to last post
  26. 280 pistons in a 1998 225 promax

    Started by racervboat, 09-18-2022 10:55 AM
    • Replies: 2
    • Views: 291
    09-19-2022, 07:59 AM Go to last post
  27. Sorting out a Frankenstein'd 2.4/200

    Started by pcrussell50, 08-16-2022 01:42 PM
    • Replies: 13
    • Views: 1,348
    09-18-2022, 09:07 PM Go to last post
  28. 2L race block

    Started by Merc 2.5, 09-16-2022 05:55 PM
    • Replies: 5
    • Views: 696
    09-17-2022, 02:33 PM Go to last post
  29. 5 pedal or 7 pedal

    Started by 1989 champion, 09-14-2022 09:26 AM
    • Replies: 3
    • Views: 430
    09-17-2022, 10:52 AM Go to last post
  30. Repacement plugs

    Started by twin2.5, 09-16-2022 11:33 AM
    • Replies: 1
    • Views: 213
    09-16-2022, 01:02 PM Go to last post
  31. Mercury Tech: 2.5l mercury overheating

    Started by Smalltownbassin, 07-04-2022 04:01 PM
    5 Pages
    1 2 3 4 5
    • Replies: 69
    • Views: 2,035
    09-16-2022, 12:18 PM Go to last post
  32. 300x oiling system

    Started by Wild Bill, 09-16-2022 10:20 AM
    • Replies: 0
    • Views: 113
    09-16-2022, 10:20 AM Go to last post
  33. HPDI Rebuild Issues

    Started by AD1988, 08-01-2022 08:04 AM
    • Replies: 5
    • Views: 443
    09-16-2022, 09:46 AM Go to last post
  34. 240 EFI Gen 2 SJ - Keeps fouling plugs

    Started by 240EFIGen2, 09-16-2022 09:46 AM
    • Replies: 0
    • Views: 119
    09-16-2022, 09:46 AM Go to last post
  35. high voltaage

    Started by MercNovice, 06-02-2004 08:48 PM
    • Replies: 9
    • Views: 828
    09-16-2022, 03:58 AM Go to last post
  36. Mercury Tech: lower with driveshaft nut or without... any crucial differences?

    Started by pcrussell50, 09-08-2022 10:29 PM
    • Replies: 8
    • Views: 702
    09-15-2022, 10:21 PM Go to last post

Page 1 of 7 1 2 3 4 5 6 7 LastLast

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 75 views
Hot thread with unread posts
More than 15 replies or 75 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Frank Mole Transport