Performance Boat Revolution: What Happened to the Affordable Performance Boat? — Wave To Wave
I suppose this is not a new topic, but it's
By Lars Strom
Starting with: Paris 6 hours 1973..OMC V6 victory over Team Mercury.
I think I kinda jump on everybody else's threads and it's not long before they get pissed of with me, so if I do my very own thread I can't upset anyone
Last Post By: WaterZebra Today, 09:33 AMNew to the forum and need some direction. My 200 efi bogs coming out of the hole….just sits there at 2000 rpm for as long as you want to stay on the throttle.
Last Post By: XstreamVking Today, 09:07 AMOK so I have a Merc Gen 2 side mount shift/throttle control on my Checkmate that's giving me problems.
Can anyone give me the part number
Used these when installing EFI outboard that required a fuel return line because tank had no provision for a return line.
Typical application
Doing some spring cleaning on all electrical connections. Can't find where ground cable is connected. Looks like it goes up behind the starter and or
Last Post By: Jim Speros Today, 06:33 AMBest steering setup I've ever used, super solid and precise, Loads better than the single Imco which I had on there before!
Fits on Powerhead
I got this Tahiti a month ago and it had the giant back-to-back seats in covering up most of the front of the floor. Upon removing them, I found the whole
Last Post By: rgsauger Today, 12:03 AMHave a 1993 XR6, 4-1/4" lower unit, clean freshwater unit, 20" RH, 1:78 gears, new seals. Part #1674-814247-C.
$850, prefer pickup, can
I always run klotz higher octane booster with 93 in my 300x, marine stabile, and a little sea foam, just curious between the 4 vs 2 strokes opinions
Last Post By: rgsauger Yesterday, 11:51 PM2.5 torquemaster 1:87 ratio (year 2000)
Part # 43-822824
note: the forward # is 813687
the pinion # is 813688
buying a 175 merc optimax pro xs. on boat but not rigged. what all do i need?
Thread Starter: derekflhe claims it is an almost no hour motor. and looks it. never had a head bolt loosened and flywheel and starter teeth look like they never met. so i
Last Post By: derekfl Today, 09:55 AM