32 Max 5 ST
Clean edges and blades. No issues with prop. I sold my old boat as I bought this and don’t use it on my current boat.
Finished taking my 2.5 260 horn motor apart today after a rod went thru the block on #6. The bottom crank seal was sucking water and air and that's
Last Post By: wogi Yesterday, 08:42 PMAnyone have a 300xs air compressor they want to part with? A source where to find one would be helpful too. Thanks in advance.
Last Post By: RADER Yesterday, 08:25 PM98 200 efi with a 260 cover. Everything related to the power head and two piece adapter plates are factory 98 pieces. All cooling is routed as per factory
Last Post By: LakeFever Yesterday, 08:07 PMWanted a Quiksilver control box top mount, with trim and tilt single motor
i am in new jersey
I laugh every time I see this.
I just had a rod go thru the block on my 2.5 260 and all the plugs were white! Last week they were normal tan. What are some of the things that would
Last Post By: LakeFever Yesterday, 06:51 PMI expect quite a few here have seen this photo of a one off CVX 20 Surface drive from back in the 70's.
I know nothing about
1988 OMC V-8. Need reeds,30 years old.
Two pedals broke in one hole. Found remnants of one pedal. Still need to find the other
I had these cut to 300X specs by Hydro Tec and decided not to use them, they are EFI heads, will not work on Opti’s $600 plus shipping!
Last Post By: riverracer2 Yesterday, 04:46 PMI have a fresh water ros clamp and trim bracket, no pump or hoses !! $750 plus shipping.
Last Post By: riverracer2 Yesterday, 04:46 PMI have a set of tall BBC valve covers with vents and hardware $250 plus shipping!! You can text me at 573-42nine-501nine
Last Post By: riverracer2 Yesterday, 04:45 PMHi all, i would like to add a reservoir to my 2.4 seastar pump.
I ordered a 1/4 npt fitting as per the manual this should be the correct
Small shaft. Not Flo torq. Will post pics this weekend. $650 shipped.
Last Post By: Asstracker Yesterday, 02:43 PM
Got to re-link and sync but… question
Thread Starter: pcrussell502.4/200
Last Post By: skialot2 Today, 01:00 AM-starts and idles like a champ
-screams up to high rpm under no load
-screams when it is on the mains
BUT