Post a random photo thread! Add yours!
Post a random pic Thread i will Start Freeze Frame
Add yours
other forum has one of these
Beautiful, 1988 Hydrostream Verado. Rigged with Mariner 200HP 2.5L. Boat sits on a 2014 Shorelander Trailer. The boat was recently rigged with the
Last Post By: Seven Lakes Marine Today, 07:20 AMI expect quite a few here have seen this photo of a one off CVX 20 Surface drive from back in the 70's.
I know nothing about
I hate fuel pumps in the boat. Is it ok to mount a pump under the cowl on a horn motor? Can it suck fuel that far without a primer bulb? How long can
Last Post By: mercrazy Today, 06:40 AMLets see the some pictures. Weather was great, hope the water conditions were as well.
Joe
I’ve seen several new 2 stroke motorcycles being introduced. Is light weight and simplicity making a comeback? Will this ever happen in outboards? I know
Last Post By: LakeFever Today, 05:24 AM
By Lars Strom
Starting with: Paris 6 hours 1973..OMC V6 victory over Team Mercury.
guys im installing a new boat side wireing harness on a 24 ft off shore after measureing arround turns ect i figured 32 ft total after hooking up i have
Last Post By: redsnapper386 Today, 12:01 AMJust switched from an efi to carb on a 95 150. Took the carbs and intake of a done engine. Cleaned carbs new everything. Motor runs fine on hose and in
Last Post By: pcrussell50 Yesterday, 09:58 PMAre stock 2.5 rod bolts safe at 7000 rpm?
What about used ones?
Are WSM standard bolts the same as Promarine, Buckshot, etc.?
Hydrogen Outboard. Interesting. But, in my opinion, to make it practical, they need to invent an onboard Hydrogen generator that can produce enough hydrogen
Last Post By: pcrussell50 Yesterday, 09:49 PMBrand new, never installed. Part number 1647-9147c4. 20” 1:87. Just now installed impeller and gear lube. Pick up in Jonesborough, TN. Pictures on Facebook.
Last Post By: mercrazy Yesterday, 04:09 PM
Mechanical Trim Tabs
Thread Starter: InstigatorPretty cool set up if you need some help w/set up.
Last Post By: SENC Today, 07:33 AMMechanically adjustable.
The is not corrosion but appears to be mold???