Charlie Poveromo making some runs with his 1975 Viper at Markham Park in Florida. According to the GoPro GPS, the best run was 111.1 MPH. That boat is
Last Post By: XstreamVking Today, 11:41 AMHydrogen compressed to high density, and comparative to other power sources at a lighter energy storage-weight.
Toyota is at the forefront
Finally, the 300R's showed up. Couple months late. Getting cold here so will have to wait for spring to test. Plus, I will need to do some fabrication
Last Post By: John S Today, 11:32 AMI am looking for a used 93772A1 2 stroke marine advance module.The question is that I have been told
that I do not need that on the motor. I am
From the Golden Era
Found some old pictures ( don't know why I keep saying that, hell....all my stuff is old )
#254 -
The most reliable engine will probably always be in the "eye of the beholder", or owner.
Ford’s Inline 6 has a 70-pound crankshaft
Wel I finally spun an upper bearing on my 88' yam 40hp etlg. Like always looking to go a little faster. Looking to put it on a 14' novuraina rib. So I
Last Post By: Z06man Today, 10:27 AMHi I'm Joe. Wanted a boat and my old man was not ready to give up his 21 Checkmate Startflite so I hunted around and found a Predictor to redo.
2nd owner, always stored indoors, original except gauges, gps speedo etc.
incl. 2005 Easyloader gala. trailer.
Original 140
Hey guys, don't have any pics right now. Just wondering everyone's thoughts... what do you think I could sell my pair of second effort v8s , duel plug
Last Post By: Telnet1337 Today, 09:53 AMSHIPPING INCLUDED___U.S> ONLY LOWER 48
3/4 wp cover --SOLD
Tach 8k-SOLD
Autometer 60psi fuel gauge -SOLD
Mercury
Come on up to Palatka, FL and join the river run on the St John's river down to Salt Springs and Silver Glen . The river is big and wide and is the largest
Last Post By: JR IN JAX Today, 09:36 AMThe chubby crankshaft rollers fell everywhere in the garage - how many per bearing assembly are there ??
What is the part number for the
This shaft and carrier have been laying around for 2 yrs waiting to be finished.
Today was the day.
The propshaft got machined to 30mm which
Offset cylinder engine
Thread Starter: CDaveThis is pretty cool.
Last Post By: Dave S Today, 12:02 PM