I always run klotz higher octane booster with 93 in my 300x, marine stabile, and a little sea foam, just curious between the 4 vs 2 strokes opinions
Last Post By: Will hedrick Today, 12:08 AMI know this site leans more towards boats that are built basically for high performance racing,skiing,etc etc but I have a love for the fast bass boats
Last Post By: ksfastman Yesterday, 11:34 PMMade a run of velocity stacks, there made from 6061 aluminum and are 1/2 thick. Stacks will fit wh and wmh carbs and come with stainless cap screws.
Last Post By: 89Talon18 Yesterday, 10:53 PMDoes anyone have any wing plates to suit Mercury 2 piece exhaust plates.
Motor is a standard 200hp.
2011 Mercury 300XS with DBR kit. Has 1.75 Sporty and a custom foil added. Recently had the injectors cleaned and flowed with 775 hours. Son just accepted
Last Post By: cgates2193 Yesterday, 09:31 PMWe should see some real big numbers this year LOTO is going to do official KILO runs .No limit on speed entering traps and have to back it up the other
Last Post By: CUDA Yesterday, 09:24 PMI think we need one. If you are a gearhead, it is not limited to boats.
So post a pic of your ride!
I lucked up on this
On Mercury engines, what are the small seals on the lower unit’s drain plug and vent screw made of? Are they cardboard (which makes no sense) or some
Last Post By: Jim Speros Yesterday, 08:40 PMI laugh every time I see this.
Anybody have any experience with the Mayfair/Imco Outboard inside steering kit from Hardin or CP? Looking for something to pair with my Imco side ram.
Last Post By: Guppy Yesterday, 07:56 PMI know most of you guys run Mercury, but I thought I'd throw this up here anyhow.
I have a whole bunch of new Suzuki Stainless Steel props,
Just throwing around an idea here, mates.
My background is machining, molds. 40 years worth.
There is nobody out there that I have seen recently
This has been talked about in another thread but since it got some traction there I wanted to start a new thread to make sure any potential interested
Last Post By: aj06bolt12r Yesterday, 05:30 PMHello everyone, my first post here!
I have a 1984 baja 184ss with a 2.4 200 carb merc on the back. I have recently sent off my lower unit
Custom cut 2.5 o-ring heads
Thread Starter: 89Talon18Custom 37cc cnc machined o-ring heads for a standard bore zero deck height oring motor. Heads have fully machined chambers with a .043" x 2 degree
Last Post By: 89Talon18 Today, 12:51 AM