I laugh every time I see this.
Needs a Refurb! Mercury Chopper prop. 14.5, RH, 24P. Some damage on blades and needs a refurb, but should clean up nice. Part Number 48-77320A5.
Last Post By: gem56 Today, 05:02 PMI expect quite a few here have seen this photo of a one off CVX 20 Surface drive from back in the 70's.
I know nothing about
What is the best or easiest way to install or remove Mercury's PVS hole plugs.
Last Post By: sonicss33 Today, 04:32 PMLooking for a set of brackets for a Uflex PTS-1 paddle trim unit. I purchased a used PTS-1 and come to find out they have two different size brackets
Last Post By: David - WI Today, 03:27 PMLooking to find a stock 32 ET for a multi engine set up so they match. Would like to sell this one. 9 of 10.
$800 shipped continental
Ok so adding photos didnt go so well.
These engines seem to be covered/ buried in conflicting info& lots& lots of claims of
https://electrek.co/2025/04/20/tesla...g-brake-issue/
Last Post By: CUDA Today, 02:38 PMThe engines seem to be quite close together in power due perhaps to the drag of the larger 500r gearcase, with a 15,000 dollar difference. yes the 450
Last Post By: river rocket Today, 02:35 PMLooking for entire front half or just intake. Thanks
Last Post By: levi ledet Today, 02:15 PMHi all, has anyone tried drilling of the head bolts into the exhaust port of a mercury 3L engine ? I wanna ask around see if anyone has done it before
Last Post By: aj06bolt12r Today, 01:59 PMI just picked up a NEW N-control foot throttle that I don't need. It is missing a small bracket that holds the return spring but I am making that this
Last Post By: Galazkiewicz Today, 01:41 PMhttps://thefederalist.com/2025/04/15...ding-on-china/
Last Post By: CUDA Today, 12:22 PM
Q for Smartcraft experts
Thread Starter: TraceF3I just bought a 2006 Mercury 2.5L 150 EFI. Serial number is shown.
Last Post By: HydroSkreamin Today, 06:42 PMI installed a Merc monitor, the small squarish gauge that goes in a 2